arm: am335x: DXR2: Move unconditional LAN9303 reset into command
The switch HW reset results in a disconnection of the switch port daisy- chain for a few seconds. This is not desired in the normal field use case. So lets remove this switch reset from the normal bootup sequence and move it into a board specific command. This way it can be executed in the development environment when really needed. Signed-off-by: Stefan Roese <sr@denx.de> Cc: Roger Meier <r.meier@siemens.com> Cc: Lukas Stockmann <lukas.stockmann@siemens.com> Cc: Tom Rini <trini@ti.com>
This commit is contained in:
parent
ef59bb7cc8
commit
ec716e33d6
@ -232,13 +232,6 @@ int board_eth_init(bd_t *bis)
|
||||
|
||||
factoryset_setenv();
|
||||
|
||||
/* Reset SMSC LAN9303 switch for default configuration */
|
||||
gpio_request(GPIO_LAN9303_NRST, "nRST");
|
||||
gpio_direction_output(GPIO_LAN9303_NRST, 0);
|
||||
/* assert active low reset for 200us */
|
||||
udelay(200);
|
||||
gpio_set_value(GPIO_LAN9303_NRST, 1);
|
||||
|
||||
/* Set rgmii mode and enable rmii clock to be sourced from chip */
|
||||
writel((RMII_MODE_ENABLE | RMII_CHIPCKL_ENABLE), &cdev->miisel);
|
||||
|
||||
@ -249,6 +242,25 @@ int board_eth_init(bd_t *bis)
|
||||
n += rv;
|
||||
return n;
|
||||
}
|
||||
|
||||
static int do_switch_reset(cmd_tbl_t *cmdtp, int flag, int argc,
|
||||
char *const argv[])
|
||||
{
|
||||
/* Reset SMSC LAN9303 switch for default configuration */
|
||||
gpio_request(GPIO_LAN9303_NRST, "nRST");
|
||||
gpio_direction_output(GPIO_LAN9303_NRST, 0);
|
||||
/* assert active low reset for 200us */
|
||||
udelay(200);
|
||||
gpio_set_value(GPIO_LAN9303_NRST, 1);
|
||||
|
||||
return 0;
|
||||
};
|
||||
|
||||
U_BOOT_CMD(
|
||||
switch_rst, CONFIG_SYS_MAXARGS, 1, do_switch_reset,
|
||||
"Reset LAN9303 switch via its reset pin",
|
||||
""
|
||||
);
|
||||
#endif /* #if defined(CONFIG_DRIVER_TI_CPSW) */
|
||||
#endif /* #if (defined(CONFIG_DRIVER_TI_CPSW) && !defined(CONFIG_SPL_BUILD)) */
|
||||
|
||||
|
Loading…
Reference in New Issue
Block a user