Fix various typos, scattered over the code.

Spelling corrections for (among other things):

* environment
* override
* variable
* ftd (should be "fdt", for flattened device tree)
* embedded
* FTDI
* emulation
* controller

drivers/bios_emulator/x86emu/decode.c

@@ -241,7 +241,7 @@ no segment override. Address modes such as -3[BP] or 10[BP+SI] all refer to
 addresses relative to SS (ie: on the stack). So, at the minimum, all
 decodings of addressing modes would have to set/clear a bit describing
 whether the access is relative to DS or SS.  That is the function of the
-cpu-state-varible M.x86.mode. There are several potential states:
+cpu-state-variable M.x86.mode. There are several potential states:
 
     repe prefix seen  (handled elsewhere)
     repne prefix seen  (ditto)

drivers/dfu/Kconfig

@@ -3,8 +3,8 @@ menu "DFU support"
 config DFU_TFTP
 	bool "DFU via TFTP"
 	help
-	  This option allows performing update of DFU managed medium with data
-	  send via TFTP boot.
-	  Detailed description of this feature can be found at ./doc/README.dfutftp
+	  This option allows performing update of DFU-managed medium with data
+	  sent via TFTP boot.
 
+	  Detailed description of this feature can be found at ./doc/README.dfutftp
 endmenu

drivers/net/macb.c

@@ -120,7 +120,7 @@ static int macb_is_gem(struct macb_device *macb)
 static int gem_is_gigabit_capable(struct macb_device *macb)
 {
 	/*
-	 * The GEM controllers embeded in SAMA5D2 and SAMA5D4 are
+	 * The GEM controllers embedded in SAMA5D2 and SAMA5D4 are
 	 * configured to support only 10/100.
 	 */
 	return macb_is_gem(macb) && !cpu_is_sama5d2() && !cpu_is_sama5d4();

drivers/net/sh_eth.c

@@ -1,5 +1,5 @@
 /*
- * sh_eth.c - Driver for Renesas ethernet controler.
+ * sh_eth.c - Driver for Renesas ethernet controller.
  *
  * Copyright (C) 2008, 2011 Renesas Solutions Corp.
  * Copyright (c) 2008, 2011, 2014 2014 Nobuhiro Iwamatsu

drivers/net/sh_eth.h

@@ -1,5 +1,5 @@
 /*
- * sh_eth.h - Driver for Renesas SuperH ethernet controler.
+ * sh_eth.h - Driver for Renesas SuperH ethernet controller.
  *
  * Copyright (C) 2008 - 2012 Renesas Solutions Corp.
  * Copyright (c) 2008 - 2012 Nobuhiro Iwamatsu

drivers/thermal/Kconfig

@@ -1,7 +1,7 @@
 config DM_THERMAL
 	bool "Driver support for thermal devices"
 	help
-	  Enable support for temporary-sensing devices. Some SoCs have on-chip
+	  Enable support for temperature-sensing devices. Some SoCs have on-chip
 	  temperature sensors to permit warnings, speed throttling or even
 	  automatic power-off when the temperature gets too high or low. Other
 	  devices may be discrete but connected on a suitable bus.