forked from Minki/linux
cc4f9c2a91
The 64-bit set of updates this release cycle adds support for three new platforms: - Samsunc Exynos 7 - Freescale LS2085a - Mediatek MT8173 For all these, the changes mostly consititude additions of DT contents, but also some Kconfig entries to allow dependency/selection of drivers per-platform, etc. -----BEGIN PGP SIGNATURE----- Version: GnuPG v1 iQIcBAABAgAGBQJU4vKcAAoJEIwa5zzehBx358oQAInkGDQLBIl758u0VlXFvKnW NaMewMzH6R32hpDD8sr9zk/xdeS9BkN4nQzg49lFBHj6GbxtEYY94cpdYebjwntj Mg5tj99Mc1xlN0EwFEkBttf7gBd2JpPPhqKLKAfHaypeHlxyQkcLBWAq5vJbQHS9 Iar2C6HsCBbpmbSFf3xI/w0Q16HlYmXxrICKIU1ZzqQzSo3IJM/6yFjNKlgbbdWN aQr5KVZtAgQLSuU4BCBYy3hvxS794bk3DdDpyYXa7RNAv5/zG/mU127HHYMFtM8K Ebk2ksbq2KolulMvKCxO2sLqlKgGRaSY5L54Ab5OXsd3Hys4YqgOyOxdE6AP++Ro gUn+bjfFsJ+9xmYoAQwPCWF9nz1YBLdhr72fcV5eR8Jq0b6VgT8ELI6/gYePfccJ 5efWPev8qFvuBwgHLTf5NKFC2UN14nI3yUf9znez5OwyRs38PaXP2ju/hg1jd8d3 1zJEj93oUvWggmUya+5PvX9G6X5dgYoobQVLKycRfXNH47gf906ArcQRASJbMPNA 3HZFFnBzOBkb9MLwx1HbXRabIxGGqjzmhWr0efq6WZzg8cG/VoeAgPZBOGnRmzDV aPK+tFhmm/drACdAI6V3Pff7YLsQF0GBfOmGUgO+4NzezvKRzBGFXU9pohvpsxSI vyNhKL54OlI2eMfTR/XM =FuwP -----END PGP SIGNATURE----- Merge tag '64bit-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc Pull ARM SoC 64-bit changes and additions from Olof Johansson: "The 64-bit set of updates this release cycle adds support for three new platforms: - Samsunc Exynos 7 - Freescale LS2085a - Mediatek MT8173 For all these, the changes mostly consititude additions of DT contents, but also some Kconfig entries to allow dependency/selection of drivers per-platform, etc" * tag '64bit-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: arm64: Kconfig: clean up two no-op Kconfig options from CONFIG_ARCH_TEGRA* arm64: Fix sort of platform Kconfig entries arm64: Add support for FSL's LS2085A SoC in Kconfig and defconfig arm64: Add DTS support for FSL's LS2085A SoC arm64: mediatek: Add MT8173 SoC Kconfig and defconfig arm64: dts: Add mediatek MT8173 SoC and evaluation board dts and Makefile Document: DT: Add bindings for mediatek MT8173 SoC Platform arm64: Add Tegra132 support arm64: Enable ARMv8 based exynos7 SoC support arm64: dts: Add nodes for mmc, i2c, rtc, watchdog, adc on exynos7 arm64: dts: Add PMU DT node for exynos7 SoC arm64: dts: Add initial pinctrl support to exynos7 arm64: dts: Add initial device tree support for exynos7
27 lines
815 B
Plaintext
27 lines
815 B
Plaintext
* Mediatek Universal Asynchronous Receiver/Transmitter (UART)
|
|
|
|
Required properties:
|
|
- compatible should contain:
|
|
* "mediatek,mt8135-uart" for MT8135 compatible UARTS
|
|
* "mediatek,mt8127-uart" for MT8127 compatible UARTS
|
|
* "mediatek,mt8173-uart" for MT8173 compatible UARTS
|
|
* "mediatek,mt6589-uart" for MT6589 compatible UARTS
|
|
* "mediatek,mt6582-uart" for MT6582 compatible UARTS
|
|
* "mediatek,mt6577-uart" for all compatible UARTS (MT8173, MT6589, MT6582,
|
|
MT6577)
|
|
|
|
- reg: The base address of the UART register bank.
|
|
|
|
- interrupts: A single interrupt specifier.
|
|
|
|
- clocks: Clock driving the hardware.
|
|
|
|
Example:
|
|
|
|
uart0: serial@11006000 {
|
|
compatible = "mediatek,mt6589-uart", "mediatek,mt6577-uart";
|
|
reg = <0x11006000 0x400>;
|
|
interrupts = <GIC_SPI 51 IRQ_TYPE_LEVEL_LOW>;
|
|
clocks = <&uart_clk>;
|
|
};
|