Most SIMD instructions use the 66/f2/f3 prefixes to distinguish between
different variants of the same instruction. Usually the encoding is quite
regular, but in some cases (including non-SIMD instructions) the prefixes
generate very different instructions. Examples include XCHG/PAUSE,
MOVQ/MOVDQA/MOVDQU, and MOVBE/CRC32.
Allow the emulator to handle these special cases by splitting such opcodes
into groups, with different decode flags and execution functions for different
prefixes.
Signed-off-by: Avi Kivity <avi@redhat.com>
Currently we store a rep prefix as 1 or 2 depending on whether it is a REPE or
REPNE. Since sse instructions depend on the prefix value, store it as the
original opcode to simplify things further on.
Signed-off-by: Avi Kivity <avi@redhat.com>
Since sse instructions can issue 16-byte mmios, we need to support them. We
can't increase the kvm_run mmio buffer size to 16 bytes without breaking
compatibility, so instead we break the large mmios into two smaller 8-byte
ones. Since the bus is 64-bit we aren't breaking any atomicity guarantees.
Signed-off-by: Avi Kivity <avi@redhat.com>
As Avi recently mentioned, the new standard mechanism for exposing features
is KVM_GET_SUPPORTED_CPUID, not spamming CAPs. For some reason async pf
missed that.
So expose async_pf here.
Signed-off-by: Glauber Costa <glommer@redhat.com>
CC: Gleb Natapov <gleb@redhat.com>
CC: Avi Kivity <avi@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
Use vmx_set_nmi_mask() instead of open-coding management of
the hardware bit and the software hint (nmi_known_unmasked).
There's a slight change of behaviour when running without
hardware virtual NMI support - we now clear the NMI mask if
NMI delivery faulted in that case as well. This improves
emulation accuracy.
Signed-off-by: Avi Kivity <avi@redhat.com>
When we haven't injected an interrupt, we don't need to recover
the nmi blocking state (since the guest can't set it by itself).
This allows us to avoid a VMREAD later on.
Signed-off-by: Avi Kivity <avi@redhat.com>
We may read the cpl quite often in the same vmexit (instruction privilege
check, memory access checks for instruction and operands), so we gain
a bit if we cache the value.
Signed-off-by: Avi Kivity <avi@redhat.com>
In long mode, vm86 mode is disallowed, so we need not check for
it. Reading rflags.vm may require a VMREAD, so it is expensive.
Signed-off-by: Avi Kivity <avi@redhat.com>
Some rflags bits are owned by the host, not guest, so we need to use
kvm_get_rflags() to strip those bits away or kvm_set_rflags() to add them
back.
Signed-off-by: Avi Kivity <avi@redhat.com>
We can get memslot id from memslot->id directly
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6: (27 commits)
slcan: fix ldisc->open retval
net/usb: mark LG VL600 LTE modem ethernet interface as WWAN
xfrm: Don't allow esn with disabled anti replay detection
xfrm: Assign the inner mode output function to the dst entry
net: dev_close() should check IFF_UP
vlan: fix GVRP at dismantle time
netfilter: revert a2361c8735
netfilter: IPv6: fix DSCP mangle code
netfilter: IPv6: initialize TOS field in REJECT target module
IPVS: init and cleanup restructuring
IPVS: Change of socket usage to enable name space exit.
netfilter: ebtables: only call xt_compat_add_offset once per rule
netfilter: fix ebtables compat support
netfilter: ctnetlink: fix timestamp support for new conntracks
pch_gbe: support ML7223 IOH
PCH_GbE : Fixed the issue of checksum judgment
PCH_GbE : Fixed the issue of collision detection
NET: slip, fix ldisc->open retval
be2net: Fixed bugs related to PVID.
ehea: fix wrongly reported speed and port
...
This reverts commit 4a5fa3590f, which did not allow SLUB to be used
on architectures that use DISCONTIGMEM without compiling NUMA support
without CONFIG_BROKEN also set.
The slub panic that it was intended to prevent is addressed by
d9b41e0b54 ("[PARISC] set memory ranges in N_NORMAL_MEMORY when
onlined") on parisc so there is no further slub issues with such a
configuration.
The reverts allows SLUB now to be used on such architectures since
there haven't been any reports of additional errors.
Cc: James Bottomley <James.Bottomley@suse.de>
Signed-off-by: David Rientjes <rientjes@google.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
TTY layer expects 0 if the ldisc->open operation succeeded.
Reported-by: Matvejchikov Ilya <matvejchikov@gmail.com>
Signed-off-by: Oliver Hartkopp <socketcan@hartkopp.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Like other mobile broadband device ethernet interfaces, mark the LG
VL600 with the 'wwan' devtype so userspace knows it needs additional
configuration via the AT port before the interface can be used.
Signed-off-by: Dan Williams <dcbw@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Unlike the standard case, disabled anti replay detection needs some
nontrivial extra treatment on ESN. RFC 4303 states:
Note: If a receiver chooses to not enable anti-replay for an SA, then
the receiver SHOULD NOT negotiate ESN in an SA management protocol.
Use of ESN creates a need for the receiver to manage the anti-replay
window (in order to determine the correct value for the high-order
bits of the ESN, which are employed in the ICV computation), which is
generally contrary to the notion of disabling anti-replay for an SA.
So return an error if an ESN state with disabled anti replay detection
is inserted for now and add the extra treatment later if we need it.
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
As it is, we assign the outer modes output function to the dst entry
when we create the xfrm bundle. This leads to two problems on interfamily
scenarios. We might insert ipv4 packets into ip6_fragment when called
from xfrm6_output. The system crashes if we try to fragment an ipv4
packet with ip6_fragment. This issue was introduced with git commit
ad0081e4 (ipv6: Fragment locally generated tunnel-mode IPSec6 packets
as needed). The second issue is, that we might insert ipv4 packets in
netfilter6 and vice versa on interfamily scenarios.
With this patch we assign the inner mode output function to the dst entry
when we create the xfrm bundle. So xfrm4_output/xfrm6_output from the inner
mode is used and the right fragmentation and netfilter functions are called.
We switch then to outer mode with the output_finish functions.
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Commit 443457242b (factorize sync-rcu call in
unregister_netdevice_many) mistakenly removed one test from dev_close()
Following actions trigger a BUG :
modprobe bonding
modprobe dummy
ifconfig bond0 up
ifenslave bond0 dummy0
rmmod dummy
dev_close() must not close a non IFF_UP device.
With help from Frank Blaschka and Einar EL Lueck
Reported-by: Frank Blaschka <blaschka@linux.vnet.ibm.com>
Reported-by: Einar EL Lueck <ELELUECK@de.ibm.com>
Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
* 'for-linus' of git://oss.sgi.com/xfs/xfs:
xfs: fix race condition in AIL push trigger
xfs: make AIL target updates and compares 32bit safe.
xfs: always push the AIL to the target
xfs: exit AIL push work correctly when AIL is empty
xfs: ensure reclaim cursor is reset correctly at end of AG
This fixes:
alchemy/xxs1500/init.c: In function 'prom_init':
alchemy/xxs1500/init.c:57:17: error: ignoring return value of 'kstrtoul', declared with attribute warn_unused_result
Signed-off-by: Manuel Lauss <manuel.lauss@googlemail.com>
Cc: Linux-MIPS <linux-mips@linux-mips.org>
Patchwork: https://patchwork.linux-mips.org/patch/2340/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
PAGE_SIZE >= 64kb (1 << 16) is too big to be the immediate of the
addiu/daddiu instruction, so, use addu/daddu instruction instead.
The following compiling error is fixed:
AS arch/mips/power/hibernate.o
arch/mips/power/hibernate.S: Assembler messages:
arch/mips/power/hibernate.S:38: Error: expression out of range
make[2]: *** [arch/mips/power/hibernate.o] Error 1
make[1]: *** [arch/mips/power] Error 2
Reported-by: Roman Mamedov <rm@romanrm.ru>
Signed-off-by: Wu Zhangjin <wuzhangjin@gmail.com>
To: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/2313/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
The code for supporting one-shot mode for the clockevent is already there,
only the feature flag was not set. Setting the one-shot flag allows the
kernel to run in tickless mode.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/2261/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
CC arch/mips/jz4740/dma.o
arch/mips/jz4740/dma.c: In function 'jz4740_dma_chan_irq':
arch/mips/jz4740/dma.c:245:11: error: variable 'status' set but not used [-Werro
r=unused-but-set-variable]
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
HOSTCC arch/mips/boot/compressed/calc_vmlinuz_load_addr
arch/mips/boot/compressed/calc_vmlinuz_load_addr.c: In function 'main':
arch/mips/boot/compressed/calc_vmlinuz_load_addr.c:35:2: warning: format '%llx' expects type 'long long unsigned int *', but argument 3 has type 'uint64_t *'
arch/mips/boot/compressed/calc_vmlinuz_load_addr.c:54:2: warning: format '%llx' expects type 'long long unsigned int', but argument 2 has type 'uint64_t'
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
CC arch/mips/alchemy/devboards/db1x00/board_setup.o
arch/mips/alchemy/devboards/db1x00/board_setup.c: In function 'board_setup':
arch/mips/alchemy/devboards/db1x00/board_setup.c:130:6: error: variable 'pin_func' set but not used [-Werror=unused-but-set-variable]
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
CC arch/mips/sgi-ip27/ip27-hubio.o
arch/mips/sgi-ip27/ip27-hubio.c: In function 'hub_pio_map':
arch/mips/sgi-ip27/ip27-hubio.c:32:20: error: variable 'junk' set but not used [-Werror=unused-but-set-variable]
cc1: all warnings being treated as errors
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
CC arch/mips/sgi-ip27/ip27-hubio.o
arch/mips/sgi-ip27/ip27-hubio.c: In function 'hub_pio_map':
arch/mips/sgi-ip27/ip27-hubio.c:32:20: error: variable 'junk' set but not used [-Werror=unused-but-set-variable]
cc1: all warnings being treated as errors
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Instead of making each Octeon specific option depend on
CPU_CAVIUM_OCTEON, gate the body of the entire file with
CPU_CAVIUM_OCTEON. With this change, CAVIUM_OCTEON_SPECIFIC_OPTIONS
becomes useless, so get rid of it as well.
Signed-off-by: David Daney <ddaney@caviumnetworks.com>
To: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/2091/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Octeon doesn't use IRQ_CPU, so don't select it.
IRQ_CPU_OCTEON is a completely unused symbol, remove it completely.
Signed-off-by: David Daney <ddaney@caviumnetworks.com>
To: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/2086/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
