linux/arch/x86/include/asm/pgtable_32.h

/* SPDX-License-Identifier: GPL-2.0 */
#ifndef _ASM_X86_PGTABLE_32_H
#define _ASM_X86_PGTABLE_32_H

#include <asm/pgtable_32_types.h>

/*
 * The Linux memory management assumes a three-level page table setup. On
 * the i386, we use that, but "fold" the mid level into the top-level page
 * table, so that we physically have the same two-level page table as the
 * i386 mmu expects.
 *
 * This file contains the functions and defines necessary to modify and use
 * the i386 page table tree.
 */
#ifndef __ASSEMBLY__
#include <asm/processor.h>
#include <linux/threads.h>
#include <asm/paravirt.h>

#include <linux/bitops.h>
#include <linux/list.h>
#include <linux/spinlock.h>

struct mm_struct;
struct vm_area_struct;

extern pgd_t swapper_pg_dir[1024];
extern pgd_t initial_page_table[1024];
extern pmd_t initial_pg_pmd[];

static inline void pgtable_cache_init(void) { }
static inline void check_pgt_cache(void) { }
void paging_init(void);
void sync_initial_page_table(void);

static inline int pgd_large(pgd_t pgd) { return 0; }

/*
 * Define this if things work differently on an i386 and an i486:
 * it will (on an i486) warn about kernel memory accesses that are
 * done without a 'access_ok(VERIFY_WRITE,..)'
 */
#undef TEST_ACCESS_OK

#ifdef CONFIG_X86_PAE
# include <asm/pgtable-3level.h>
#else
# include <asm/pgtable-2level.h>
#endif

#if defined(CONFIG_HIGHPTE)
#define pte_offset_map(dir, address)					\
	((pte_t *)kmap_atomic(pmd_page(*(dir))) +		\
	 pte_index((address)))
#define pte_unmap(pte) kunmap_atomic((pte))
#else
#define pte_offset_map(dir, address)					\
	((pte_t *)page_address(pmd_page(*(dir))) + pte_index((address)))
#define pte_unmap(pte) do { } while (0)
#endif

/* Clear a kernel PTE and flush it from the TLB */
#define kpte_clear_flush(ptep, vaddr)		\
do {						\
	pte_clear(&init_mm, (vaddr), (ptep));	\
	__flush_tlb_one_kernel((vaddr));		\
} while (0)

#endif /* !__ASSEMBLY__ */

/*
 * kern_addr_valid() is (1) for FLATMEM and (0) for
 * SPARSEMEM and DISCONTIGMEM
 */
#ifdef CONFIG_FLATMEM
#define kern_addr_valid(addr)	(1)
#else
#define kern_addr_valid(kaddr)	(0)
#endif

/*
 * This is how much memory in addition to the memory covered up to
 * and including _end we need mapped initially.
 * We need:
 *     (KERNEL_IMAGE_SIZE/4096) / 1024 pages (worst case, non PAE)
 *     (KERNEL_IMAGE_SIZE/4096) / 512 + 4 pages (worst case for PAE)
 *
 * Modulo rounding, each megabyte assigned here requires a kilobyte of
 * memory, which is currently unreclaimed.
 *
 * This should be a multiple of a page.
 *
 * KERNEL_IMAGE_SIZE should be greater than pa(_end)
 * and small than max_low_pfn, otherwise will waste some page table entries
 */
#if PTRS_PER_PMD > 1
#define PAGE_TABLE_SIZE(pages) (((pages) / PTRS_PER_PMD) + PTRS_PER_PGD)
#else
#define PAGE_TABLE_SIZE(pages) ((pages) / PTRS_PER_PGD)
#endif

/*
 * Number of possible pages in the lowmem region.
 *
 * We shift 2 by 31 instead of 1 by 32 to the left in order to avoid a
 * gas warning about overflowing shift count when gas has been compiled
 * with only a host target support using a 32-bit type for internal
 * representation.
 */
#define LOWMEM_PAGES ((((2<<31) - __PAGE_OFFSET) >> PAGE_SHIFT))

#endif /* _ASM_X86_PGTABLE_32_H */