a4fa811463
cmd/Makefile has: ifdef CONFIG_FPGA obj-$(CONFIG_CMD_FPGA) += fpga.o endif which means that if CONFIG_FPGA is not set, CONFIG_CMD_FPGA silently does nothing. Let's remove that Makefile conditional and instead express this equivalent dependency in Kconfig, so a lot of redundant # CONFIG_CMD_FPGA is not set can be removed from board defconfigs that don't actually have an FPGA. Signed-off-by: Tuomas Tynkkynen <tuomas@tuxera.com>
31 lines
948 B
Plaintext
31 lines
948 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_MACH_SUN5I=y
|
|
CONFIG_DRAM_CLK=432
|
|
CONFIG_DRAM_EMR1=0
|
|
CONFIG_MMC0_CD_PIN="PG0"
|
|
CONFIG_MMC_SUNXI_SLOT_EXTRA=2
|
|
CONFIG_USB0_VBUS_PIN="PB04"
|
|
CONFIG_USB0_VBUS_DET="PG01"
|
|
CONFIG_USB0_ID_DET="PG2"
|
|
CONFIG_AXP_GPIO=y
|
|
# CONFIG_VIDEO_HDMI is not set
|
|
CONFIG_VIDEO_LCD_MODE="x:480,y:800,depth:18,pclk_khz:25000,le:2,ri:93,up:2,lo:93,hs:1,vs:1,sync:3,vmode:0"
|
|
CONFIG_VIDEO_LCD_DCLK_PHASE=0
|
|
CONFIG_VIDEO_LCD_POWER="PG4"
|
|
CONFIG_VIDEO_LCD_RESET="PG11"
|
|
CONFIG_VIDEO_LCD_BL_EN="AXP0-1"
|
|
CONFIG_VIDEO_LCD_BL_PWM="PB2"
|
|
CONFIG_VIDEO_LCD_TL059WV5C0=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun5i-a13-utoo-p66"
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL=y
|
|
CONFIG_SPL_I2C_SUPPORT=y
|
|
# CONFIG_CMD_FLASH is not set
|
|
# CONFIG_SPL_DOS_PARTITION is not set
|
|
# CONFIG_SPL_ISO_PARTITION is not set
|
|
# CONFIG_SPL_EFI_PARTITION is not set
|
|
# CONFIG_REQUIRE_SERIAL_CONSOLE is not set
|
|
CONFIG_USB_MUSB_HOST=y
|
|
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
|