u-boot/configs/x600_defconfig
Tom Rini cbabe7f87f configs: Migrate and re-enabled CONFIG_CMD_MTDPARTS
Now that CMD_UBI does not select CMD_MTDPARTS we need to make platforms
that had been enabling it turn it on by hand.  This exposed that we had
not yet migrated CMD_MTDPARTS fully, so do so now.

Fixes: 86dfa556d9 ("cmd: ubi: Remove useless call to mtdparts_init()")
Signed-off-by: Tom Rini <trini@konsulko.com>
2018-11-14 10:53:27 -05:00

63 lines
1.5 KiB
Plaintext

CONFIG_ARM=y
CONFIG_SYS_THUMB_BUILD=y
# CONFIG_SPL_USE_ARCH_MEMCPY is not set
# CONFIG_SPL_USE_ARCH_MEMSET is not set
CONFIG_TARGET_X600=y
CONFIG_SYS_TEXT_BASE=0x00800040
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_SPL=y
CONFIG_IDENT_STRING="-SPEAr"
CONFIG_NR_DRAM_BANKS=1
CONFIG_BOOTDELAY=3
CONFIG_SYS_CONSOLE_INFO_QUIET=y
CONFIG_MISC_INIT_R=y
# CONFIG_DISPLAY_BOARDINFO is not set
CONFIG_SPL_NOR_SUPPORT=y
CONFIG_HUSH_PARSER=y
CONFIG_SYS_PROMPT="X600> "
CONFIG_AUTOBOOT_KEYED=y
CONFIG_AUTOBOOT_PROMPT="Hit SPACE in %d seconds to stop autoboot.\n"
CONFIG_AUTOBOOT_STOP_STR=" "
CONFIG_CMD_IMLS=y
CONFIG_LOOPW=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
CONFIG_CMD_NAND=y
CONFIG_CMD_SAVES=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_DHCP=y
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_DATE=y
CONFIG_CMD_FAT=y
CONFIG_CMD_FS_GENERIC=y
CONFIG_CMD_MTDPARTS=y
CONFIG_MTDIDS_DEFAULT="nand0=nand"
CONFIG_MTDPARTS_DEFAULT="mtdparts=nand:64M(ubi0),64M(ubi1)"
CONFIG_CMD_UBI=y
CONFIG_ENV_IS_IN_FLASH=y
CONFIG_BOOTCOUNT_LIMIT=y
CONFIG_SYS_BOOTCOUNT_ADDR=0xD2801FF8
CONFIG_FPGA_XILINX=y
CONFIG_FPGA_SPARTAN3=y
CONFIG_SYS_I2C_DW=y
# CONFIG_MMC is not set
CONFIG_MTD_NOR_FLASH=y
CONFIG_PHY_ADDR_ENABLE=y
CONFIG_PHY_MICREL=y
CONFIG_PHY_MICREL_KSZ90X1=y
CONFIG_ETH_DESIGNWARE=y
CONFIG_MII=y
CONFIG_CONS_INDEX=0
CONFIG_USB=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_STORAGE=y
CONFIG_BCH=y
CONFIG_USE_TINY_PRINTF=y
CONFIG_OF_LIBFDT=y
# CONFIG_EFI_LOADER is not set