u-boot

History

Masahiro Yamada 1221ce459d treewide: replace #include <asm/errno.h> with <linux/errno.h> Now, arch/${ARCH}/include/asm/errno.h and include/linux/errno.h have the same content. (both just wrap <asm-generic/errno.h>) Replace all include directives for <asm/errno.h> with <linux/errno.h>. Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> [trini: Fixup include/clk.] Signed-off-by: Tom Rini <trini@konsulko.com>		2016-09-23 17:55:42 -04:00
..
Kconfig	mx6: remove SYS_SOC from board Kconfig	2015-09-13 10:37:29 +02:00
MAINTAINERS	MAINTAINERS/mailmap: Update my email address	2016-01-11 11:22:43 -05:00
Makefile	wandboard: Switch to SPL support	2015-05-21 18:08:37 +02:00
README	Use correct spelling of "U-Boot"	2016-02-06 12:00:59 +01:00
spl.c	treewide: replace #include <asm/errno.h> with <linux/errno.h>	2016-09-23 17:55:42 -04:00
wandboard.c	wandboard: Replace is_cpu_type() for macro	2016-07-28 13:27:19 +02:00

README

U-Boot for Wandboard
--------------------

This file contains information for the port of U-Boot to the Wandboard.

Wandboard is a development board that has three variants based on the following
SoCs: mx6 quad, mx6 dual lite and mx6 solo.

For more details about Wandboard, please refer to:
http://www.wandboard.org/

Building U-Boot for Wandboard
-----------------------------

To build U-Boot for the Wandboard:

$ make wandboard_config
$ make

Flashing U-Boot into the SD card
--------------------------------

- After the 'make' command completes, the generated 'SPL' binary must be
flashed into the SD card;

$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

(Note - the SD card node may vary, so adjust this as needed).

- Flash the u-boot.img image into the SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)

- Connect the serial cable to the host PC

- Power up the board and U-Boot messages will appear in the serial console.