08574ed339
This converts the following to Kconfig: CONFIG_SYS_MONITOR_LEN To do this, we set a default of 0 for everyone because there are a number of cases where we define CONFIG_SYS_MONITOR_LEN but the only impact is that we set TOTAL_MALLOC_LEN to be CONFIG_SYS_MALLOC_LEN + CONFIG_ENV_SIZE, so we must continue to allow all boards to set this value. Update the SPL code to use 200 KB as the default raw U-Boot size directly, if we don't have a real CONFIG_SYS_MONITOR_LEN value. Signed-off-by: Tom Rini <trini@konsulko.com> Reviewed-by: Simon Glass <sjg@chromium.org>
26 lines
852 B
Plaintext
26 lines
852 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun6i-a31s-primo81"
|
|
CONFIG_SPL=y
|
|
CONFIG_MACH_SUN6I=y
|
|
CONFIG_DRAM_CLK=360
|
|
CONFIG_DRAM_ZQ=122
|
|
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
|
|
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
|
|
CONFIG_AXP_GPIO=y
|
|
CONFIG_VIDEO_LCD_MODE="x:768,y:1024,depth:18,pclk_khz:66000,le:56,ri:60,up:30,lo:36,hs:64,vs:50,sync:3,vmode:0"
|
|
CONFIG_VIDEO_LCD_BL_EN="PA25"
|
|
CONFIG_VIDEO_LCD_BL_PWM="PH13"
|
|
CONFIG_VIDEO_LCD_PANEL_MIPI_4_LANE_513_MBPS_VIA_SSD2828=y
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SYS_MONITOR_LEN=786432
|
|
CONFIG_AXP_DLDO1_VOLT=3300
|
|
# CONFIG_REQUIRE_SERIAL_CONSOLE is not set
|
|
CONFIG_USB_MUSB_HOST=y
|
|
CONFIG_VIDEO_LCD_SSD2828_TX_CLK=27
|
|
CONFIG_VIDEO_LCD_SSD2828_RESET="PA26"
|
|
CONFIG_VIDEO_LCD_SPI_CS="PH9"
|
|
CONFIG_VIDEO_LCD_SPI_SCLK="PH10"
|
|
CONFIG_VIDEO_LCD_SPI_MOSI="PH11"
|
|
CONFIG_VIDEO_LCD_SPI_MISO="PH12"
|