u-boot

History

Josua Mayer 6cf1cc987f mx6cuboxi: fix board detection while patching device-tree phy nodes ft_board_setup relies on the board_type() function to optimize which phy nodes need to be enabled for Linux. Add calls to setup and release the board-detect GPIOs. Also fix the switch-case statement to only enable phy address 4 for Cubox and unknown devices. Fixes: `741ce308` ("mx6cuboxi: fixup dtb ethernet phy nodes before booting an OS") Signed-off-by: Josua Mayer <josua@solid-run.com>		2022-07-25 15:08:23 +02:00
..
Kconfig	mx6: remove SYS_SOC from board Kconfig	2015-09-13 10:37:29 +02:00
MAINTAINERS	MAINTAINERS: Use my personal e-mail address	2021-04-08 20:29:53 +02:00
Makefile	SPDX: Convert all of our single license tags to Linux Kernel style	2018-05-07 09:34:12 -04:00
mx6cuboxi.c	mx6cuboxi: fix board detection while patching device-tree phy nodes	2022-07-25 15:08:23 +02:00
README	Use correct spelling of "U-Boot"	2016-02-06 12:00:59 +01:00

README

How to use U-Boot on Solid-run mx6 Hummingboard and Cubox-i
-----------------------------------------------------------

- Build U-Boot for Hummingboard/Cubox-i:

$ make mrproper
$ make mx6cuboxi_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Insert the SD card in the board, power it up and U-Boot messages should
come up.