f7ae49fc4f
Move this header out of the common header. Signed-off-by: Simon Glass <sjg@chromium.org>
180 lines
4.0 KiB
C
180 lines
4.0 KiB
C
// SPDX-License-Identifier: GPL-2.0+
|
|
/*
|
|
* Copyright (C) 2016 Stefan Roese <sr@denx.de>
|
|
*/
|
|
|
|
#include <common.h>
|
|
#include <altera.h>
|
|
#include <errno.h>
|
|
#include <log.h>
|
|
#include <asm/gpio.h>
|
|
#include <asm/io.h>
|
|
#include <asm/arch/cpu.h>
|
|
#include <asm/arch/soc.h>
|
|
#include <asm/arch-mvebu/spi.h>
|
|
#include "theadorable.h"
|
|
|
|
/*
|
|
* FPGA programming support
|
|
*/
|
|
static int fpga_pre_fn(int cookie)
|
|
{
|
|
int gpio_config = COOKIE2CONFIG(cookie);
|
|
int gpio_done = COOKIE2DONE(cookie);
|
|
int ret;
|
|
|
|
debug("%s (%d): cookie=%08x gpio_config=%d gpio_done=%d\n",
|
|
__func__, __LINE__, cookie, gpio_config, gpio_done);
|
|
|
|
/* Configure config pin */
|
|
/* Set to output */
|
|
ret = gpio_request(gpio_config, "CONFIG");
|
|
if (ret < 0)
|
|
return ret;
|
|
gpio_direction_output(gpio_config, 1);
|
|
|
|
/* Configure done pin */
|
|
/* Set to input */
|
|
ret = gpio_request(gpio_done, "DONE");
|
|
if (ret < 0)
|
|
return ret;
|
|
|
|
gpio_direction_input(gpio_done);
|
|
|
|
return 0;
|
|
}
|
|
|
|
static int fpga_config_fn(int assert, int flush, int cookie)
|
|
{
|
|
int gpio_config = COOKIE2CONFIG(cookie);
|
|
|
|
debug("%s (%d): cookie=%08x gpio_config=%d\n",
|
|
__func__, __LINE__, cookie, gpio_config);
|
|
|
|
if (assert)
|
|
gpio_set_value(gpio_config, 1);
|
|
else
|
|
gpio_set_value(gpio_config, 0);
|
|
|
|
return 0;
|
|
}
|
|
|
|
static int fpga_write_fn(const void *buf, size_t len, int flush, int cookie)
|
|
{
|
|
int spi_bus = COOKIE2SPI_BUS(cookie);
|
|
int spi_dev = COOKIE2SPI_DEV(cookie);
|
|
struct kwspi_registers *reg;
|
|
u32 control_reg;
|
|
u32 config_reg;
|
|
void *dst;
|
|
|
|
/*
|
|
* Write data to FPGA attached to SPI bus via SPI direct write.
|
|
* This results in the fastest and easiest way to program the
|
|
* bitstream into the FPGA.
|
|
*/
|
|
debug("%s (%d): cookie=%08x spi_bus=%d spi_dev=%d\n",
|
|
__func__, __LINE__, cookie, spi_bus, spi_dev);
|
|
|
|
if (spi_bus == 0) {
|
|
reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10600);
|
|
dst = (void *)SPI_BUS0_DEV1_BASE;
|
|
} else {
|
|
reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10680);
|
|
dst = (void *)SPI_BUS1_DEV2_BASE;
|
|
}
|
|
|
|
/* Configure SPI controller for direct access mode */
|
|
control_reg = readl(®->ctrl);
|
|
config_reg = readl(®->cfg);
|
|
writel(0x00000214, ®->cfg); /* 27MHz clock */
|
|
writel(0x00000000, ®->dw_cfg); /* don't de-asset CS */
|
|
writel(KWSPI_CSN_ACT, ®->ctrl); /* activate CS */
|
|
|
|
/* Copy data to the SPI direct mapped window */
|
|
memcpy(dst, buf, len);
|
|
|
|
/* Restore original register values */
|
|
writel(control_reg, ®->ctrl);
|
|
writel(config_reg, ®->cfg);
|
|
|
|
return 0;
|
|
}
|
|
|
|
/* Returns the state of CONF_DONE Pin */
|
|
static int fpga_done_fn(int cookie)
|
|
{
|
|
int gpio_done = COOKIE2DONE(cookie);
|
|
unsigned long ts;
|
|
|
|
debug("%s (%d): cookie=%08x gpio_done=%d\n",
|
|
__func__, __LINE__, cookie, gpio_done);
|
|
|
|
ts = get_timer(0);
|
|
do {
|
|
if (gpio_get_value(gpio_done))
|
|
return 0;
|
|
} while (get_timer(ts) < 1000);
|
|
|
|
/* timeout so return error */
|
|
return -ENODEV;
|
|
}
|
|
|
|
static altera_board_specific_func stratixv_fns = {
|
|
.pre = fpga_pre_fn,
|
|
.config = fpga_config_fn,
|
|
.write = fpga_write_fn,
|
|
.done = fpga_done_fn,
|
|
};
|
|
|
|
static Altera_desc altera_fpga[] = {
|
|
{
|
|
/* Family */
|
|
Altera_StratixV,
|
|
/* Interface type */
|
|
passive_serial,
|
|
/* No limitation as additional data will be ignored */
|
|
-1,
|
|
/* Device function table */
|
|
(void *)&stratixv_fns,
|
|
/* Base interface address specified in driver */
|
|
NULL,
|
|
/* Cookie implementation */
|
|
/*
|
|
* In this 32bit word the following information is coded:
|
|
* Bit 31 ... Bit 0
|
|
* SPI-Bus | SPI-Dev | Config-Pin | Done-Pin
|
|
*/
|
|
FPGA_COOKIE(0, 1, 26, 7)
|
|
},
|
|
{
|
|
/* Family */
|
|
Altera_StratixV,
|
|
/* Interface type */
|
|
passive_serial,
|
|
/* No limitation as additional data will be ignored */
|
|
-1,
|
|
/* Device function table */
|
|
(void *)&stratixv_fns,
|
|
/* Base interface address specified in driver */
|
|
NULL,
|
|
/* Cookie implementation */
|
|
/*
|
|
* In this 32bit word the following information is coded:
|
|
* Bit 31 ... Bit 0
|
|
* SPI-Bus | SPI-Dev | Config-Pin | Done-Pin
|
|
*/
|
|
FPGA_COOKIE(1, 2, 29, 9)
|
|
},
|
|
};
|
|
|
|
/* Add device descriptor to FPGA device table */
|
|
void board_fpga_add(void)
|
|
{
|
|
int i;
|
|
|
|
fpga_init();
|
|
for (i = 0; i < ARRAY_SIZE(altera_fpga); i++)
|
|
fpga_add(fpga_altera, &altera_fpga[i]);
|
|
}
|