73223f0e1b
There are already two FIT options in Kconfig but the CONFIG options are still in the header files. We need to do a proper move to fix this. Move these options to Kconfig and tidy up board configuration: CONFIG_FIT CONFIG_OF_BOARD_SETUP CONFIG_OF_SYSTEM_SETUP CONFIG_FIT_SIGNATURE CONFIG_FIT_BEST_MATCH CONFIG_FIT_VERBOSE CONFIG_OF_STDOUT_VIA_ALIAS CONFIG_RSA Unfortunately the first one is a little complicated. We need to make sure this option is not enabled in SPL by this change. Also this option is enabled automatically in the host builds by defining CONFIG_FIT in the image.h file. To solve this, add a new IMAGE_USE_FIT #define which can be used in files that are built on the host but must also build for U-Boot and SPL. Note: Masahiro's moveconfig.py script is amazing. Signed-off-by: Simon Glass <sjg@chromium.org> [trini: Add microblaze change, various configs/ re-applies] Signed-off-by: Tom Rini <trini@konsulko.com>
29 lines
909 B
Plaintext
29 lines
909 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_MACH_SUN6I=y
|
|
CONFIG_DRAM_CLK=360
|
|
CONFIG_DRAM_ZQ=122
|
|
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
|
|
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
|
|
CONFIG_AXP_GPIO=y
|
|
CONFIG_VIDEO_LCD_MODE="x:768,y:1024,depth:18,pclk_khz:66000,le:56,ri:60,up:30,lo:36,hs:64,vs:50,sync:3,vmode:0"
|
|
CONFIG_VIDEO_LCD_BL_EN="PA25"
|
|
CONFIG_VIDEO_LCD_BL_PWM="PH13"
|
|
CONFIG_VIDEO_LCD_PANEL_MIPI_4_LANE_513_MBPS_VIA_SSD2828=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun6i-a31s-primo81"
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL=y
|
|
CONFIG_OF_BOARD_SETUP=y
|
|
# CONFIG_CMD_IMLS is not set
|
|
# CONFIG_CMD_FLASH is not set
|
|
# CONFIG_CMD_FPGA is not set
|
|
CONFIG_CMD_GPIO=y
|
|
CONFIG_AXP_DLDO1_VOLT=3300
|
|
CONFIG_USB_MUSB_HOST=y
|
|
CONFIG_VIDEO_LCD_SSD2828_TX_CLK=27
|
|
CONFIG_VIDEO_LCD_SSD2828_RESET="PA26"
|
|
CONFIG_VIDEO_LCD_SPI_CS="PH9"
|
|
CONFIG_VIDEO_LCD_SPI_SCLK="PH10"
|
|
CONFIG_VIDEO_LCD_SPI_MOSI="PH11"
|
|
CONFIG_VIDEO_LCD_SPI_MISO="PH12"
|