u-boot/include/configs/tqma6_wru4.h
Stefan Roese 8b8ca0d7d8 arm: mx6: Remove SPI support from WRU-IV baseboard
This patch removes the SPI support from the WRU-IV baseboard as its
not used at all.

Signed-off-by: Stefan Roese <sr@denx.de>
Cc: Clemens Gruber <clemens.gruber@pqgruber.com>
Cc: Markus Niebel <Markus.Niebel@tq-group.com>
Cc: Stefano Babic <sbabic@denx.de>
Tested-by: Clemens Gruber <clemens.gruber@pqgruber.com>
Reviewed-by: Jagan Teki <jteki@openedev.com>
2015-09-02 15:26:11 +02:00

80 lines
2.0 KiB
C

/*
* Copyright (C) 2015 Stefan Roese <sr@denx.de>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#ifndef __CONFIG_TQMA6_WRU4_H
#define __CONFIG_TQMA6_WRU4_H
#define CONFIG_DEFAULT_FDT_FILE "imx6s-wru4.dtb"
/* DTT sensors */
#define CONFIG_DTT_SENSORS { 0, 1 }
#define CONFIG_SYS_DTT_BUS_NUM 2
/* Ethernet */
#define CONFIG_FEC_XCV_TYPE RMII
#define CONFIG_ETHPRIME "FEC"
#define CONFIG_FEC_MXC_PHYADDR 0x01
#define CONFIG_PHY_SMSC
/* UART */
#define CONFIG_MXC_UART_BASE UART4_BASE
#define CONFIG_CONSOLE_DEV "ttymxc3"
#define CONFIG_MISC_INIT_R
/* Watchdog */
#define CONFIG_HW_WATCHDOG
#define CONFIG_IMX_WATCHDOG
#define CONFIG_WATCHDOG_TIMEOUT_MSECS 60000
/* Config on-board RTC */
#define CONFIG_RTC_DS1337
#define CONFIG_SYS_RTC_BUS_NUM 2
#define CONFIG_SYS_I2C_RTC_ADDR 0x68
/* Turn off RTC square-wave output to save battery */
#define CONFIG_SYS_RTC_DS1337_NOOSC
#define CONFIG_CMD_DATE
#define CONFIG_CMD_GPIO
/* LED */
#define CONFIG_CMD_LED
#define CONFIG_STATUS_LED
#define CONFIG_BOARD_SPECIFIC_LED
#define STATUS_LED_BIT 0
#define STATUS_LED_STATE STATUS_LED_ON
#define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2)
#define STATUS_LED_BIT1 1
#define STATUS_LED_STATE1 STATUS_LED_ON
#define STATUS_LED_PERIOD1 (CONFIG_SYS_HZ / 2)
#define STATUS_LED_BIT2 2
#define STATUS_LED_STATE2 STATUS_LED_ON
#define STATUS_LED_PERIOD2 (CONFIG_SYS_HZ / 2)
#define STATUS_LED_BIT3 3
#define STATUS_LED_STATE3 STATUS_LED_ON
#define STATUS_LED_PERIOD3 (CONFIG_SYS_HZ / 2)
#define STATUS_LED_BIT4 4
#define STATUS_LED_STATE4 STATUS_LED_ON
#define STATUS_LED_PERIOD4 (CONFIG_SYS_HZ / 2)
#define STATUS_LED_BIT5 5
#define STATUS_LED_STATE5 STATUS_LED_ON
#define STATUS_LED_PERIOD5 (CONFIG_SYS_HZ / 2)
/* Bootcounter */
#define CONFIG_BOOTCOUNT_LIMIT
#define CONFIG_SYS_BOOTCOUNT_ADDR IRAM_BASE_ADDR
#define CONFIG_SYS_BOOTCOUNT_BE
/*
* Remove all unused interfaces / commands that are defined in
* the common header tqms6.h
*/
#undef CONFIG_CMD_SF
#undef CONFIG_CMD_SPI
#undef CONFIG_MXC_SPI
#endif /* __CONFIG_TQMA6_WRU4_H */