29d280c88a
Onc of key blocker for using USB Generic host controller drivers in Allwinner are CLK and RESET drivers, now these available for USB usage. So switch sunxi USB use EHCI and OHCI Generic controllers. Enabling USB is wisely a board choise, So Enable USB_OHCI_HCD where it already have USB_EHCI_HCD Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> Acked-by: Maxime Ripard <maxime.ripard@bootlin.com>
30 lines
896 B
Plaintext
30 lines
896 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_SPL=y
|
|
CONFIG_MACH_SUN8I_A33=y
|
|
CONFIG_DRAM_CLK=432
|
|
CONFIG_DRAM_ZQ=15291
|
|
CONFIG_DRAM_ODT_EN=y
|
|
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
|
|
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
|
|
CONFIG_USB0_ID_DET="PH8"
|
|
CONFIG_AXP_GPIO=y
|
|
CONFIG_VIDEO_LCD_MODE="x:1024,y:600,depth:18,pclk_khz:52000,le:138,ri:162,up:22,lo:10,hs:20,vs:3,sync:3,vmode:0"
|
|
CONFIG_VIDEO_LCD_DCLK_PHASE=0
|
|
CONFIG_VIDEO_LCD_POWER="PH7"
|
|
CONFIG_VIDEO_LCD_BL_EN="PH6"
|
|
CONFIG_VIDEO_LCD_BL_PWM="PH0"
|
|
CONFIG_VIDEO_LCD_PANEL_LVDS=y
|
|
CONFIG_NR_DRAM_BANKS=1
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
# CONFIG_CMD_FLASH is not set
|
|
# CONFIG_SPL_DOS_PARTITION is not set
|
|
# CONFIG_SPL_EFI_PARTITION is not set
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun8i-a33-ga10h-v1.1"
|
|
CONFIG_AXP_DLDO1_VOLT=3300
|
|
CONFIG_CONS_INDEX=5
|
|
CONFIG_USB_OHCI_HCD=y
|
|
CONFIG_USB_EHCI_HCD=y
|
|
CONFIG_USB_MUSB_HOST=y
|
|
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
|