ad12dc1844
Having this as a 'default y' is rather annoying because it doesn't
actually compile unless other options are defined in the board header:
../cmd/bootm.c: In function 'do_imls_nor':
../cmd/bootm.c:330:7: error: 'CONFIG_SYS_MAX_FLASH_BANKS' undeclared (first use in this function); did you mean 'CONFIG_SYS_MAX_FLASH_SECT'?
i < CONFIG_SYS_MAX_FLASH_BANKS; ++i, ++info) {
Make it 'default n' so people who develop new boards that start from a
blank defconfig have one less compilation failure to debug.
Signed-off-by: Tuomas Tynkkynen <tuomas.tynkkynen@iki.fi>
31 lines
1.0 KiB
Plaintext
31 lines
1.0 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_MACH_SUN6I=y
|
|
CONFIG_DRAM_CLK=360
|
|
CONFIG_DRAM_ZQ=122
|
|
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
|
|
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
|
|
CONFIG_AXP_GPIO=y
|
|
CONFIG_VIDEO_LCD_MODE="x:768,y:1024,depth:18,pclk_khz:66000,le:56,ri:60,up:30,lo:36,hs:64,vs:50,sync:3,vmode:0"
|
|
CONFIG_VIDEO_LCD_BL_EN="PA25"
|
|
CONFIG_VIDEO_LCD_BL_PWM="PH13"
|
|
CONFIG_VIDEO_LCD_PANEL_MIPI_4_LANE_513_MBPS_VIA_SSD2828=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun6i-a31s-primo81"
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL=y
|
|
# CONFIG_CMD_FLASH is not set
|
|
# CONFIG_CMD_FPGA is not set
|
|
# CONFIG_SPL_DOS_PARTITION is not set
|
|
# CONFIG_SPL_ISO_PARTITION is not set
|
|
# CONFIG_SPL_EFI_PARTITION is not set
|
|
CONFIG_AXP_DLDO1_VOLT=3300
|
|
# CONFIG_REQUIRE_SERIAL_CONSOLE is not set
|
|
CONFIG_USB_MUSB_HOST=y
|
|
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
|
|
CONFIG_VIDEO_LCD_SSD2828_TX_CLK=27
|
|
CONFIG_VIDEO_LCD_SSD2828_RESET="PA26"
|
|
CONFIG_VIDEO_LCD_SPI_CS="PH9"
|
|
CONFIG_VIDEO_LCD_SPI_SCLK="PH10"
|
|
CONFIG_VIDEO_LCD_SPI_MOSI="PH11"
|
|
CONFIG_VIDEO_LCD_SPI_MISO="PH12"
|