0963060c99
Port for the PHYTEC phyBOARD-i.MX6UL-Segin single board computer. Based on the PHYTEC phyCORE-i.MX6UL SOM (PCL063). CPU: Freescale i.MX6UL rev1.2 528 MHz (running at 396 MHz) CPU: Industrial temperature grade (-40C to 105C) at 44C Reset cause: POR Board: PHYTEC phyCORE-i.MX6UL I2C: ready DRAM: 256 MiB NAND: 512 MiB MMC: FSL_SDHC: 0 In: serial Out: serial Err: serial Net: FEC0 Working: - Eth0 - i2C - MMC/SD - NAND - UART (1 & 5) - USB (host & otg) Signed-off-by: Martyn Welch <martyn.welch@collabora.com>
27 lines
721 B
Plaintext
27 lines
721 B
Plaintext
How to use U-Boot on PHYTEC phyBOARD-i.MX6UL-Segin
|
|
--------------------------------------------------
|
|
|
|
- Configure and build U-Boot for phyCORE-i.MX6UL:
|
|
|
|
$ make mrproper
|
|
$ make phycore_pcl063_defconfig
|
|
$ make
|
|
|
|
This will generate SPL and u-boot-dtb.img images.
|
|
|
|
- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:
|
|
|
|
$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
|
|
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync
|
|
|
|
- Jumper settings:
|
|
|
|
JP1: Open: Boot from NAND
|
|
Closed: Boot from SD/MMC1
|
|
|
|
- Connect the Serial cable to UART0 and the PC for the console.
|
|
|
|
- Insert the micro SD card in the board and power it up.
|
|
|
|
- U-Boot messages should come up.
|