5d6a64f71d
This converts removes the following symbols: CONFIG_HAS_ETH0 CONFIG_HAS_ETH1 CONFIG_HAS_ETH2 CONFIG_HAS_ETH3 This is because at this point, only the ids8313 platform was using the code which was controlled by these symbols. In turn, this code already performs error checking on being able to perform the device tree fixup. Rather than convert these to Kconfig for a single platform, update the code to not need these checks and remove them from all the platforms they were unused on. Reviewed-by: Heiko Schocher <hs@denx.de> Signed-off-by: Tom Rini <trini@konsulko.com>
178 lines
5.0 KiB
C
178 lines
5.0 KiB
C
/* SPDX-License-Identifier: GPL-2.0+ */
|
|
/*
|
|
* Configuation settings for the Freescale MCF53017EVB.
|
|
*
|
|
* Copyright (C) 2004-2008 Freescale Semiconductor, Inc.
|
|
* TsiChung Liew (Tsi-Chung.Liew@freescale.com)
|
|
*/
|
|
|
|
/*
|
|
* board/config.h - configuration options, board specific
|
|
*/
|
|
|
|
#ifndef _M53017EVB_H
|
|
#define _M53017EVB_H
|
|
|
|
/*
|
|
* High Level Configuration Options
|
|
* (easy to change)
|
|
*/
|
|
|
|
#define CONFIG_SYS_UART_PORT (0)
|
|
|
|
#define CONFIG_WATCHDOG_TIMEOUT 5000
|
|
|
|
#define CONFIG_SYS_UNIFY_CACHE
|
|
|
|
#ifdef CONFIG_MCFFEC
|
|
# define CONFIG_MII_INIT 1
|
|
# define CONFIG_SYS_DISCOVER_PHY
|
|
# define CONFIG_SYS_RX_ETH_BUFFER 8
|
|
# define CONFIG_SYS_TX_ETH_BUFFER 8
|
|
# define CONFIG_SYS_FEC_BUF_USE_SRAM
|
|
# define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
|
|
|
|
/* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
|
|
# ifndef CONFIG_SYS_DISCOVER_PHY
|
|
# define FECDUPLEX FULL
|
|
# define FECSPEED _100BASET
|
|
# else
|
|
# ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN
|
|
# define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
|
|
# endif
|
|
# endif /* CONFIG_SYS_DISCOVER_PHY */
|
|
#endif
|
|
|
|
#define CONFIG_MCFRTC
|
|
#undef RTC_DEBUG
|
|
#define CONFIG_SYS_RTC_CNT (0x8000)
|
|
#define CONFIG_SYS_RTC_SETUP (RTC_OCEN_OSCBYP | RTC_OCEN_CLKEN)
|
|
|
|
/* Timer */
|
|
#define CONFIG_MCFTMR
|
|
|
|
/* I2C */
|
|
|
|
#ifdef CONFIG_MCFFEC
|
|
# define CONFIG_IPADDR 192.162.1.2
|
|
# define CONFIG_NETMASK 255.255.255.0
|
|
# define CONFIG_SERVERIP 192.162.1.1
|
|
# define CONFIG_GATEWAYIP 192.162.1.1
|
|
#endif /* FEC_ENET */
|
|
|
|
#define CONFIG_HOSTNAME "M53017"
|
|
#define CONFIG_EXTRA_ENV_SETTINGS \
|
|
"netdev=eth0\0" \
|
|
"loadaddr=40010000\0" \
|
|
"u-boot=u-boot.bin\0" \
|
|
"load=tftp ${loadaddr) ${u-boot}\0" \
|
|
"upd=run load; run prog\0" \
|
|
"prog=prot off 0 3ffff;" \
|
|
"era 0 3ffff;" \
|
|
"cp.b ${loadaddr} 0 ${filesize};" \
|
|
"save\0" \
|
|
""
|
|
|
|
#define CONFIG_PRAM 512 /* 512 KB */
|
|
|
|
#define CONFIG_SYS_CLK 80000000
|
|
#define CONFIG_SYS_CPU_CLK CONFIG_SYS_CLK * 3
|
|
|
|
#define CONFIG_SYS_MBAR 0xFC000000
|
|
|
|
/*
|
|
* Low Level Configuration Settings
|
|
* (address mappings, register initial values, etc.)
|
|
* You should know what you are doing if you make changes here.
|
|
*/
|
|
/*
|
|
* Definitions for initial stack pointer and data area (in DPRAM)
|
|
*/
|
|
#define CONFIG_SYS_INIT_RAM_ADDR 0x80000000
|
|
#define CONFIG_SYS_INIT_RAM_SIZE 0x20000 /* Size of used area in internal SRAM */
|
|
#define CONFIG_SYS_INIT_RAM_CTRL 0x221
|
|
#define CONFIG_SYS_GBL_DATA_OFFSET ((CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE) - 0x10)
|
|
#define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET
|
|
|
|
/*
|
|
* Start addresses for the final memory configuration
|
|
* (Set up by the startup code)
|
|
* Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
|
|
*/
|
|
#define CONFIG_SYS_SDRAM_BASE 0x40000000
|
|
#define CONFIG_SYS_SDRAM_SIZE 64 /* SDRAM size in MB */
|
|
#define CONFIG_SYS_SDRAM_CFG1 0x43711630
|
|
#define CONFIG_SYS_SDRAM_CFG2 0x56670000
|
|
#define CONFIG_SYS_SDRAM_CTRL 0xE1092000
|
|
#define CONFIG_SYS_SDRAM_EMOD 0x80010000
|
|
#define CONFIG_SYS_SDRAM_MODE 0x00CD0000
|
|
|
|
#define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE + 0x400)
|
|
#define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */
|
|
|
|
#define CONFIG_SYS_BOOTPARAMS_LEN 64*1024
|
|
|
|
/*
|
|
* For booting Linux, the board info and command line data
|
|
* have to be in the first 8 MB of memory, since this is
|
|
* the maximum mapped by the Linux kernel during initialization ??
|
|
*/
|
|
#define CONFIG_SYS_BOOTMAPSZ (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
|
|
#define CONFIG_SYS_BOOTM_LEN (CONFIG_SYS_SDRAM_SIZE << 20)
|
|
|
|
/*-----------------------------------------------------------------------
|
|
* FLASH organization
|
|
*/
|
|
#ifdef CONFIG_SYS_FLASH_CFI
|
|
# define CONFIG_FLASH_SPANSION_S29WS_N 1
|
|
# define CONFIG_SYS_FLASH_SIZE 0x1000000 /* Max size that the board might have */
|
|
# define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT
|
|
# define CONFIG_SYS_MAX_FLASH_SECT 137 /* max number of sectors on one chip */
|
|
#endif
|
|
|
|
#define CONFIG_SYS_FLASH_BASE CONFIG_SYS_CS0_BASE
|
|
|
|
/* Configuration for environment
|
|
* Environment is embedded in u-boot in the second sector of the flash
|
|
*/
|
|
|
|
#define LDS_BOARD_TEXT \
|
|
. = DEFINED(env_offset) ? env_offset : .; \
|
|
env/embedded.o(.text*)
|
|
|
|
/*-----------------------------------------------------------------------
|
|
* Cache Configuration
|
|
*/
|
|
|
|
#define ICACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \
|
|
CONFIG_SYS_INIT_RAM_SIZE - 8)
|
|
#define DCACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \
|
|
CONFIG_SYS_INIT_RAM_SIZE - 4)
|
|
#define CONFIG_SYS_ICACHE_INV (CF_CACR_CINVA)
|
|
#define CONFIG_SYS_CACHE_ACR0 (CONFIG_SYS_SDRAM_BASE | \
|
|
CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
|
|
CF_ACR_EN | CF_ACR_SM_ALL)
|
|
#define CONFIG_SYS_CACHE_ICACR (CF_CACR_EC | CF_CACR_CINVA | \
|
|
CF_CACR_DCM_P)
|
|
|
|
/*-----------------------------------------------------------------------
|
|
* Chipselect bank definitions
|
|
*/
|
|
/*
|
|
* CS0 - NOR Flash
|
|
* CS1 - Ext SRAM
|
|
* CS2 - Available
|
|
* CS3 - Available
|
|
* CS4 - Available
|
|
* CS5 - Available
|
|
*/
|
|
#define CONFIG_SYS_CS0_BASE 0
|
|
#define CONFIG_SYS_CS0_MASK 0x00FF0001
|
|
#define CONFIG_SYS_CS0_CTRL 0x00001FA0
|
|
|
|
#define CONFIG_SYS_CS1_BASE 0xC0000000
|
|
#define CONFIG_SYS_CS1_MASK 0x00070001
|
|
#define CONFIG_SYS_CS1_CTRL 0x00001FA0
|
|
|
|
#endif /* _M53017EVB_H */
|