308520b8f2
This removes the following unreferenced CONFIG symbols: CONFIG_FDTADDR CONFIG_FDTFILE CONFIG_FLASH_SECTOR_SIZE CONFIG_FSL_CPLD CONFIG_HDMI_ENCODER_I2C_ADDR CONFIG_I2C_MVTWSI CONFIG_I2C_RTC_ADDR CONFIG_IRAM_END CONFIG_IRAM_SIZE CONFIG_KSNET_MDIO_PHY_CONFIG_ENABLE CONFIG_L1_INIT_RAM CONFIG_MACB_SEARCH_PHY CONFIG_MIU_2BIT_21_7_INTERLEAVED CONFIG_MTD_NAND_VERIFY_WRITE CONFIG_MVGBE_PORTS CONFIG_NETDEV CONFIG_NUM_DSP_CPUS CONFIG_PHY_BASE_ADR CONFIG_PHY_INTERFACE_MODE CONFIG_PSRAM_SCFG CONFIG_RAMBOOT_SPIFLASH CONFIG_RAMBOOT_TEXT_BASE CONFIG_RD_LVL CONFIG_ROCKCHIP_SDHCI_MAX_FREQ CONFIG_SETUP_INITRD_TAG CONFIG_SH_QSPI_BASE CONFIG_SMDK5420 CONFIG_SOCRATES CONFIG_SPI_ADDR CONFIG_SPI_FLASH_QUAD CONFIG_SPI_FLASH_SIZE CONFIG_SPI_HALF_DUPLEX CONFIG_SPI_N25Q256A_RESET CONFIG_TEGRA_SLINK_CTRLS CONFIG_TPM_TIS_BASE_ADDRESS CONFIG_UBOOT_SECTOR_COUNT CONFIG_UBOOT_SECTOR_START CONFIG_VAR_SIZE_SPL CONFIG_VERY_BIG_RAM And also: BL1_SIZE PHY_NO RESERVE_BLOCK_SIZE Signed-off-by: Tom Rini <trini@konsulko.com>
70 lines
1.6 KiB
C
70 lines
1.6 KiB
C
/* SPDX-License-Identifier: GPL-2.0+ */
|
|
/*
|
|
* Copyright 2019-2021 NXP
|
|
*/
|
|
|
|
#ifndef __L1028A_COMMON_H
|
|
#define __L1028A_COMMON_H
|
|
|
|
#include <asm/arch/stream_id_lsch3.h>
|
|
#include <asm/arch/config.h>
|
|
#include <asm/arch/soc.h>
|
|
|
|
/* Link Definitions */
|
|
|
|
#define CFG_SYS_DDR_SDRAM_BASE 0x80000000UL
|
|
#define CFG_SYS_FSL_DDR_SDRAM_BASE_PHY 0
|
|
#define CFG_SYS_SDRAM_BASE CFG_SYS_DDR_SDRAM_BASE
|
|
#define CFG_SYS_DDR_BLOCK2_BASE 0x2080000000ULL
|
|
|
|
/*
|
|
* SMP Definitinos
|
|
*/
|
|
#define CPU_RELEASE_ADDR secondary_boot_addr
|
|
|
|
/* GPIO */
|
|
|
|
/* I2C */
|
|
|
|
/* Serial Port */
|
|
#define CFG_SYS_NS16550_CLK (get_bus_freq(0) / 2)
|
|
|
|
/* Miscellaneous configurable options */
|
|
|
|
/* Physical Memory Map */
|
|
|
|
#define HWCONFIG_BUFFER_SIZE 128
|
|
|
|
#define BOOT_TARGET_DEVICES(func) \
|
|
func(MMC, mmc, 0) \
|
|
func(MMC, mmc, 1) \
|
|
func(USB, usb, 0) \
|
|
func(DHCP, dhcp, na)
|
|
#include <config_distro_bootcmd.h>
|
|
|
|
#define XSPI_NOR_BOOTCOMMAND \
|
|
"run xspi_hdploadcmd; run distro_bootcmd; run xspi_bootcmd; " \
|
|
"env exists secureboot && esbc_halt;;"
|
|
#define SD_BOOTCOMMAND \
|
|
"run sd_hdploadcmd; run distro_bootcmd;run sd_bootcmd; " \
|
|
"env exists secureboot && esbc_halt;"
|
|
#define SD2_BOOTCOMMAND \
|
|
"run emmc_hdploadcmd; run distro_bootcmd;run emmc_bootcmd; " \
|
|
"env exists secureboot && esbc_halt;"
|
|
|
|
#define OCRAM_NONSECURE_SIZE 0x00010000
|
|
#define CFG_SYS_FSL_QSPI_BASE 0x20000000
|
|
|
|
/* I2C bus multiplexer */
|
|
#define I2C_MUX_PCA_ADDR_PRI 0x77 /* Primary Mux*/
|
|
#define I2C_MUX_CH_DEFAULT 0x8
|
|
|
|
/* DisplayPort */
|
|
#define DP_PWD_EN_DEFAULT_MASK 0x8
|
|
|
|
#ifdef CONFIG_NXP_ESBC
|
|
#include <asm/fsl_secure_boot.h>
|
|
#endif
|
|
|
|
#endif /* __L1028A_COMMON_H */
|