Remove unused symbols CONFIG_SYS_JFFS2_FIRST_BANK et al

This removes the following symbols:
   CONFIG_RTC_MCFRRTC
   CONFIG_SYS_JFFS2_FIRST_BANK
   CONFIG_SYS_JFFS2_FIRST_SECTOR
   CONFIG_SYS_JFFS2_NUM_BANKS
   CONFIG_SYS_LBC_CACHE_BASE
   CONFIG_SYS_LIME_SIZE
   CONFIG_SYS_MAMR
   CONFIG_SYS_MCFRRTC_BASE
   CONFIG_SYS_MONITOR_SEC

Signed-off-by: Tom Rini <trini@konsulko.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

README

@@ -762,11 +762,6 @@ The following options need to be configured:
 		entering dfuMANIFEST state. Host waits this timeout, before
 		sending again an USB request to the device.
 
-- Journaling Flash filesystem support:
-		CONFIG_SYS_JFFS2_FIRST_SECTOR,
-		CONFIG_SYS_JFFS2_FIRST_BANK, CONFIG_SYS_JFFS2_NUM_BANKS
-		Define these for a default partition on a NOR device
-
 - Keyboard Support:
 		See Kconfig help for available keyboard drivers.
 
@@ -1740,9 +1735,6 @@ Low Level (hardware related) configuration options:
 - CONFIG_SYS_OR_TIMING_SDRAM:
 		SDRAM timing
 
-- CONFIG_SYS_MAMR_PTA:
-		periodic timer for refresh
-
 - CONFIG_SYS_SRIO:
 		Chip has SRIO or not
 

doc/README.JFFS2

@@ -21,16 +21,6 @@ Sorting is done while inserting into the fragment list, which is
 more or less a bubble sort. That algorithm is known to be O(n^2),
 thus you should really consider if you can avoid it!
 
-
-There only one way for JFFS2 to find the disk. It uses the flash_info
-structure to find the start of a JFFS2 disk (called partition in the code)
-and you can change where the partition is with two defines.
-
-CONFIG_SYS_JFFS2_FIRST_BANK
-	defined the first flash bank to use
-
-CONFIG_SYS_JFFS2_FIRST_SECTOR
-	defines the first sector to use
 ---
 
 TODO.

include/configs/astro_mcf5373l.h

@@ -46,9 +46,6 @@
  */
 #ifdef CONFIG_RAM
 #define CONFIG_MONITOR_IS_IN_RAM
-#define ENABLE_JFFS	0
-#else
-#define ENABLE_JFFS	1
 #endif
 
 /* I2C */
@@ -210,14 +207,6 @@
 	. = DEFINED(env_offset) ? env_offset : .; \
 	env/embedded.o(.text*)
 
-#if ENABLE_JFFS
-/* JFFS Partition offset set */
-#define CONFIG_SYS_JFFS2_FIRST_BANK    0
-#define CONFIG_SYS_JFFS2_NUM_BANKS     1
-/* 512k reserved for u-boot */
-#define CONFIG_SYS_JFFS2_FIRST_SECTOR  0x40
-#endif
-
 /* Cache Configuration */
 
 #define ICACHE_STATUS			(CONFIG_SYS_INIT_RAM_ADDR + \

include/configs/at91sam9263ek.h

@@ -34,7 +34,6 @@
 #define PHYS_FLASH_1				0x10000000
 #define CONFIG_SYS_FLASH_BASE			PHYS_FLASH_1
 
-#define CONFIG_SYS_MONITOR_SEC	1:0-3
 #define CONFIG_SYS_MONITOR_LEN	(256 << 10)
 
 /* Address and size of Primary Environment Sector */

include/configs/socrates.h

@@ -78,8 +78,6 @@
 /*
  * Flash on the LocalBus
  */
-#define CONFIG_SYS_LBC_CACHE_BASE	0xf0000000	/* Localbus cacheable	 */
-
 #define CONFIG_SYS_FLASH0		0xFE000000
 #define CONFIG_SYS_FLASH1		0xFC000000
 #define CONFIG_SYS_FLASH_BANKS_LIST	{ CONFIG_SYS_FLASH1, CONFIG_SYS_FLASH0 }
@@ -108,7 +106,6 @@
 
 /* LIME GDC */
 #define CONFIG_SYS_LIME_BASE		0xc8000000
-#define CONFIG_SYS_LIME_SIZE		0x04000000	/* 64 MB	*/
 
 /*
  * General PCI

include/configs/stmark2.h

@@ -34,10 +34,6 @@
 		"sf write ${loadaddr} 0x00800000 ${filesize}\0"	\
 	""
 
-/* Realtime clock */
-#define CONFIG_RTC_MCFRRTC
-#define CONFIG_SYS_MCFRRTC_BASE		0xFC0A8000
-
 #define CONFIG_SYS_SBFHDR_SIZE		0x7
 
 /* Input, PCI, Flexbus, and VCO */

include/configs/tuxx1.h

@@ -31,8 +31,4 @@
 #include "km/km-mpc83xx.h"
 #include "km/km-mpc832x.h"
 
-#define CONFIG_SYS_MAMR		(MxMR_GPL_x4DIS | \
-				 0x0000c000 | \
-				 MxMR_WLFx_2X)
-
 #endif /* __CONFIG_H */