Cleanup

board/dbau1x00/README

@@ -13,7 +13,7 @@ configurations in little endian mode.
 I named the board dbau1x00, to allow
 support for all three development boards
 ( dbau1000, dbau1100 and dbau1500 ).
-Now there is a new board called dbau1550 also, which 
+Now there is a new board called dbau1550 also, which
 should be supported RSN.
 
 I only have a dbau1000, so my testing is limited
@@ -25,10 +25,10 @@ to test new bootloaders without thrashing the YAMON
 boot loader delivered with board.
 
 NOTE! When you switch between the two boot flashes, the
-base addresses will be swapped. 
+base addresses will be swapped.
 Have this in mind when you compile u-boot. TEXT_BASE has
-to match the address where u-boot is located when you 
-actually launch. 
+to match the address where u-boot is located when you
+actually launch.
 
 Ethernet only supported for mac0.
 

board/nc650/nc650.c

@@ -195,8 +195,7 @@ long int initdram (int board_type)
  * - short between data lines
  */
 
-static long int dram_size (long int mamr_value, long int *base,
-						   long int maxsize)
+static long int dram_size (long int mamr_value, long int *base, long int maxsize)
 {
 	volatile immap_t *immap = (immap_t *) CFG_IMMR;
 	volatile memctl8xx_t *memctl = &immap->im_memctl;
@@ -209,9 +208,10 @@ static long int dram_size (long int mamr_value, long int *base,
 #if (CONFIG_COMMANDS & CFG_CMD_NAND)
 void nand_init(void)
 {
+	extern unsigned long nand_probe(unsigned long physadr);
+
 	unsigned long totlen = nand_probe(CFG_NAND_BASE);
 
 	printf ("%4lu MB\n", totlen >> 20);
 }
 #endif
-

board/omap1510inn/platform.S

@@ -159,7 +159,7 @@ lock_end:
 	 */
 	mov r0, #0x10000000                 /* Load physical SDRAM base. */
 	mov r1, pc                          /* Get current execution location. */
-	/* Zero all but top 6 bits of PC, as they alone detect whether an 
+	/* Zero all but top 6 bits of PC, as they alone detect whether an
 	 * address is in the range 0x1000:0000-0x13ff:ffff, the 64M sized
 	 * valid range for SDRAM on the OMAP 1510/5910.
 	 */