drivers: bcm283x: Set pre-location flag for OF_BOARD
U-Boot support on Raspberry Pi 4 relies on the device-tree provided by the firmware. The blob does not contain the U-Boot specific pre-loc-rel properties. The result is, that the U-Boot banner is not printed. We fix this by setting the DM_FLAG_PRE_RELOC flag in the driver, if we rely on a device-tree provided by the firmware. Reported-by: Heinrich Schuchardt <xypron.glpk@gmx.de> Signed-off-by: Matthias Brugger <mbrugger@suse.com>
This commit is contained in:
parent
5051377a0b
commit
3f8b8e3036
@ -149,7 +149,7 @@ U_BOOT_DRIVER(pinctrl_bcm283x) = {
|
||||
.priv_auto_alloc_size = sizeof(struct bcm283x_pinctrl_priv),
|
||||
.ops = &bcm283x_pinctrl_ops,
|
||||
.probe = bcm283x_pinctl_probe,
|
||||
#if !CONFIG_IS_ENABLED(OF_CONTROL)
|
||||
#if !CONFIG_IS_ENABLED(OF_CONTROL) || CONFIG_IS_ENABLED(OF_BOARD)
|
||||
.flags = DM_FLAG_PRE_RELOC,
|
||||
#endif
|
||||
};
|
||||
|
@ -199,7 +199,7 @@ U_BOOT_DRIVER(serial_bcm283x_mu) = {
|
||||
.platdata_auto_alloc_size = sizeof(struct bcm283x_mu_serial_platdata),
|
||||
.probe = bcm283x_mu_serial_probe,
|
||||
.ops = &bcm283x_mu_serial_ops,
|
||||
#if !CONFIG_IS_ENABLED(OF_CONTROL)
|
||||
#if !CONFIG_IS_ENABLED(OF_CONTROL) || CONFIG_IS_ENABLED(OF_BOARD)
|
||||
.flags = DM_FLAG_PRE_RELOC,
|
||||
#endif
|
||||
.priv_auto_alloc_size = sizeof(struct bcm283x_mu_priv),
|
||||
|
@ -90,7 +90,7 @@ U_BOOT_DRIVER(bcm283x_pl011_uart) = {
|
||||
.platdata_auto_alloc_size = sizeof(struct pl01x_serial_platdata),
|
||||
.probe = pl01x_serial_probe,
|
||||
.ops = &bcm283x_pl011_serial_ops,
|
||||
#if !CONFIG_IS_ENABLED(OF_CONTROL)
|
||||
#if !CONFIG_IS_ENABLED(OF_CONTROL) || CONFIG_IS_ENABLED(OF_BOARD)
|
||||
.flags = DM_FLAG_PRE_RELOC,
|
||||
#endif
|
||||
.priv_auto_alloc_size = sizeof(struct pl01x_priv),
|
||||
|
Loading…
Reference in New Issue
Block a user