forked from Minki/linux
ea1e53c7f1
This patch adds the dt documentation for the usb picophy found on stih407 SoC family available from STMicroelectronics. Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com> Signed-off-by: Peter Griffin <peter.griffin@linaro.org> Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
31 lines
1.3 KiB
Plaintext
31 lines
1.3 KiB
Plaintext
ST STiH407 USB PHY controller
|
|
|
|
This file documents the dt bindings for the usb picoPHY driver which is the PHY for both USB2 and USB3
|
|
host controllers (when controlling usb2/1.1 devices) available on STiH407 SoC family from STMicroelectronics.
|
|
|
|
Required properties:
|
|
- compatible : should be "st,stih407-usb2-phy"
|
|
- reg : contain the offset and length of the system configuration registers
|
|
used as glue logic to control & parameter phy
|
|
- reg-names : the names of the system configuration registers in "reg", should be "param" and "reg"
|
|
- st,syscfg : sysconfig register to manage phy parameter at driver level
|
|
- resets : list of phandle and reset specifier pairs. There should be two entries, one
|
|
for the whole phy and one for the port
|
|
- reset-names : list of reset signal names. Should be "global" and "port"
|
|
See: Documentation/devicetree/bindings/reset/st,sti-powerdown.txt
|
|
See: Documentation/devicetree/bindings/reset/reset.txt
|
|
|
|
Example:
|
|
|
|
usb2_picophy0: usbpicophy@f8 {
|
|
compatible = "st,stih407-usb2-phy";
|
|
reg = <0xf8 0x04>, /* syscfg 5062 */
|
|
<0xf4 0x04>; /* syscfg 5061 */
|
|
reg-names = "param", "ctrl";
|
|
#phy-cells = <0>;
|
|
st,syscfg = <&syscfg_core>;
|
|
resets = <&softreset STIH407_PICOPHY_SOFTRESET>,
|
|
<&picophyreset STIH407_PICOPHY0_RESET>;
|
|
reset-names = "global", "port";
|
|
};
|