forked from Minki/linux
41f13ed46e
This patch adds binding documentation for the Samsung S5K6A3(YX) raw image sensor. Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com> Acked-by: Kyungmin Park <kyungmin.park@samsung.com> Acked-by: Mark Rutland <mark.rutland@arm.com> Signed-off-by: Mauro Carvalho Chehab <m.chehab@samsung.com>
34 lines
1.3 KiB
Plaintext
34 lines
1.3 KiB
Plaintext
Samsung S5K6A3(YX) raw image sensor
|
|
---------------------------------
|
|
|
|
S5K6A3(YX) is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces
|
|
and CCI (I2C compatible) control bus.
|
|
|
|
Required properties:
|
|
|
|
- compatible : "samsung,s5k6a3";
|
|
- reg : I2C slave address of the sensor;
|
|
- svdda-supply : core voltage supply;
|
|
- svddio-supply : I/O voltage supply;
|
|
- afvdd-supply : AF (actuator) voltage supply;
|
|
- gpios : specifier of a GPIO connected to the RESET pin;
|
|
- clocks : should contain list of phandle and clock specifier pairs
|
|
according to common clock bindings for the clocks described
|
|
in the clock-names property;
|
|
- clock-names : should contain "extclk" entry for the sensor's EXTCLK clock;
|
|
|
|
Optional properties:
|
|
|
|
- clock-frequency : the frequency at which the "extclk" clock should be
|
|
configured to operate, in Hz; if this property is not
|
|
specified default 24 MHz value will be used.
|
|
|
|
The common video interfaces bindings (see video-interfaces.txt) should be
|
|
used to specify link to the image data receiver. The S5K6A3(YX) device
|
|
node should contain one 'port' child node with an 'endpoint' subnode.
|
|
|
|
Following properties are valid for the endpoint node:
|
|
|
|
- data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in
|
|
video-interfaces.txt. The sensor supports only one data lane.
|