forked from Minki/linux
e2a240c7d3
Some synopsys ip implementation doesn't support DMA store and forward mode, such as BF60x. So, set force_thresh_dma_mode to use DMA thresholds only. Update document and devicetree as well. Signed-off-by: Sonic Zhang <sonic.zhang@analog.com> Acked-by: Giuseppe Cavallaro <peppe.cavallaro@st.com> Signed-off-by: David S. Miller <davem@davemloft.net>
45 lines
1.8 KiB
Plaintext
45 lines
1.8 KiB
Plaintext
* STMicroelectronics 10/100/1000 Ethernet driver (GMAC)
|
|
|
|
Required properties:
|
|
- compatible: Should be "snps,dwmac-<ip_version>" "snps,dwmac"
|
|
For backwards compatibility: "st,spear600-gmac" is also supported.
|
|
- reg: Address and length of the register set for the device
|
|
- interrupt-parent: Should be the phandle for the interrupt controller
|
|
that services interrupts for this device
|
|
- interrupts: Should contain the STMMAC interrupts
|
|
- interrupt-names: Should contain the interrupt names "macirq"
|
|
"eth_wake_irq" if this interrupt is supported in the "interrupts"
|
|
property
|
|
- phy-mode: String, operation mode of the PHY interface.
|
|
Supported values are: "mii", "rmii", "gmii", "rgmii".
|
|
- snps,phy-addr phy address to connect to.
|
|
- snps,reset-gpio gpio number for phy reset.
|
|
- snps,reset-active-low boolean flag to indicate if phy reset is active low.
|
|
- snps,reset-delays-us is triplet of delays
|
|
The 1st cell is reset pre-delay in micro seconds.
|
|
The 2nd cell is reset pulse in micro seconds.
|
|
The 3rd cell is reset post-delay in micro seconds.
|
|
- snps,pbl Programmable Burst Length
|
|
- snps,fixed-burst Program the DMA to use the fixed burst mode
|
|
- snps,mixed-burst Program the DMA to use the mixed burst mode
|
|
- snps,force_thresh_dma_mode Force DMA to use the threshold mode for
|
|
both tx and rx
|
|
- snps,force_sf_dma_mode Force DMA to use the Store and Forward
|
|
mode for both tx and rx. This flag is
|
|
ignored if force_thresh_dma_mode is set.
|
|
|
|
Optional properties:
|
|
- mac-address: 6 bytes, mac address
|
|
|
|
Examples:
|
|
|
|
gmac0: ethernet@e0800000 {
|
|
compatible = "st,spear600-gmac";
|
|
reg = <0xe0800000 0x8000>;
|
|
interrupt-parent = <&vic1>;
|
|
interrupts = <24 23>;
|
|
interrupt-names = "macirq", "eth_wake_irq";
|
|
mac-address = [000000000000]; /* Filled in by U-Boot */
|
|
phy-mode = "gmii";
|
|
};
|