cb272395dc
BAM is DMA controller on QCOM ipq platforms, BAM mode on NAND driver is set by writing BAM_MODE_EN bit on NAND_CTRL register. NAND_CTRL is an operational register and in BAM mode operational registers are read only. So, before enabling BAM mode by writing the NAND_CTRL register, check if BAM mode was already enabled by the bootloader, and enable BAM mode only if it is not enabled already. Signed-off-by: Sivaprakash Murugesan <sivaprak@codeaurora.org> Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com> Link: https://lore.kernel.org/linux-mtd/1591948696-16015-3-git-send-email-sivaprak@codeaurora.org |
||
|---|---|---|
| .. | ||
| onenand | ||
| raw | ||
| spi | ||
| bbt.c | ||
| core.c | ||
| Kconfig | ||
| Makefile | ||