forked from Minki/linux
bdc8cda1d0
The Xilinx XADC is a ADC that can be found in the series 7 FPGAs from Xilinx. The XADC has a DRP interface for communication. Currently two different frontends for the DRP interface exist. One that is only available on the ZYNQ family as a hardmacro in the SoC portion of the ZYNQ. The other one is available on all series 7 platforms and is a softmacro with a AXI interface. This driver supports both interfaces and internally has a small abstraction layer that hides the specifics of these interfaces from the main driver logic. The ADC has a couple of internal channels which are used for voltage and temperature monitoring of the FPGA as well as one primary and up to 16 channels auxiliary channels for measuring external voltages. The external auxiliary channels can either be directly connected each to one physical pin on the FPGA or they can make use of an external multiplexer which is responsible for multiplexing the external signals onto one pair of physical pins. The voltage and temperature monitoring channels also have an event capability which allows to generate a interrupt when their value falls below or raises above a set threshold. Buffered sampling mode is supported by the driver, but only for AXI-XADC since the ZYNQ XADC interface does not have capabilities for supporting buffer mode (no end-of-conversion interrupt). If buffered mode is supported the driver will register two triggers. One "xadc-samplerate" trigger which will generate samples with the configured samplerate. And one "xadc-convst" trigger which will generate one sample each time the CONVST (conversion start) signal is asserted. Signed-off-by: Lars-Peter Clausen <lars@metafoo.de> Signed-off-by: Jonathan Cameron <jic23@kernel.org>
28 lines
960 B
Makefile
28 lines
960 B
Makefile
#
|
|
# Makefile for IIO ADC drivers
|
|
#
|
|
|
|
# When adding new entries keep the list in alphabetical order
|
|
obj-$(CONFIG_AD_SIGMA_DELTA) += ad_sigma_delta.o
|
|
obj-$(CONFIG_AD7266) += ad7266.o
|
|
obj-$(CONFIG_AD7298) += ad7298.o
|
|
obj-$(CONFIG_AD7923) += ad7923.o
|
|
obj-$(CONFIG_AD7476) += ad7476.o
|
|
obj-$(CONFIG_AD7791) += ad7791.o
|
|
obj-$(CONFIG_AD7793) += ad7793.o
|
|
obj-$(CONFIG_AD7887) += ad7887.o
|
|
obj-$(CONFIG_AT91_ADC) += at91_adc.o
|
|
obj-$(CONFIG_EXYNOS_ADC) += exynos_adc.o
|
|
obj-$(CONFIG_LP8788_ADC) += lp8788_adc.o
|
|
obj-$(CONFIG_MAX1363) += max1363.o
|
|
obj-$(CONFIG_MCP320X) += mcp320x.o
|
|
obj-$(CONFIG_MCP3422) += mcp3422.o
|
|
obj-$(CONFIG_NAU7802) += nau7802.o
|
|
obj-$(CONFIG_TI_ADC081C) += ti-adc081c.o
|
|
obj-$(CONFIG_TI_AM335X_ADC) += ti_am335x_adc.o
|
|
obj-$(CONFIG_TWL6030_GPADC) += twl6030-gpadc.o
|
|
obj-$(CONFIG_VF610_ADC) += vf610_adc.o
|
|
obj-$(CONFIG_VIPERBOARD_ADC) += viperboard_adc.o
|
|
xilinx-xadc-y := xilinx-xadc-core.o xilinx-xadc-events.o
|
|
obj-$(CONFIG_XILINX_XADC) += xilinx-xadc.o
|