forked from Minki/linux
a77f9a282a
Jeff Kirsher says: ==================== Intel Wired LAN Driver Updates 2014-09-04 This series contains updates to i40e, i40evf, ixgbe and ixgbevf. Catherine adds dual speed module support to i40e. Updates i40e to allow the user to change link settings when the link is down. Serey renames i40e_ndo_set_vf_spoofck() to i40e_ndo_set_vf_spookchk() to be more consistent with what is defined in netdev and removes a unnecessary variable assignment. Jesse makes a malicious driver detection warning only print if extended driver string is enabled for i40e. Fixes a panic under traffic load when resetting or if/whenever there was a Tx-timeout because we were enabling the Tx queue to early. Anjali fixes an issue when PF reset fails, where we were trying to restart the admin queue which has not been setup at that point. This resolves an occasional kernel panic when PF reset fails for some reason. Ethan Zhao replaces the use of a local i40e_vfs_are_assigned() with the global kernel pci_vfs_assigned() for i40e. Alex cleans up the FDB handling for ixgbe. This change makes it so that the behavior for FDB handling is consistent between both the SR-IOV and non-SR-IOV cases. The main change is that we perform bounds checking on the number of SR-IOV addresses regardless of if SR-IOV is enabled or not as we can only support a certain number of addresses in the hardware. Emil extends the pending Tx work check to the VF interfaces, where the driver initiates a reset of the interface on link loss with pending Tx work in order to clear the rings. Introduces a delay for 82599 VFs of at least 500 usecs to make sure the VFLINKS value is correct, since this bit tends to flap when a DA or SFP+ cable is disconnected. Jacob adds code comments in ixgbe to make it more obvious that we are resetting features based on the fact that we do not have MSI-X enabled, and cannot use the previous settings. Also resolves a kernel NULL pointer dereference by limiting the combined total of MACVLAN and SR-IOV VFs, since the hardware has a limited number of pools available (64). Previously, no checks were in place to limit the number of accelerated MACVLAN devices based on the number of pools, which would be ok since there was already a limit for these well below the number of available pools. However, SR-IOV uses the very same pools, therefore we need to ensure that the total number of pools does not exceed the number of pools available in the hardware. v2: - clean up code comment in patch 5 by replacing "an" with "auto negotiation" based on feedback from Sergei Shtylyov - removed un-necessary parenthesis around function call in patch 8 based on feedback from Sergei Shtylyov ==================== |
||
|---|---|---|
| .. | ||
| 3com | ||
| 8390 | ||
| adaptec | ||
| adi | ||
| aeroflex | ||
| allwinner | ||
| alteon | ||
| altera | ||
| amd | ||
| apm | ||
| apple | ||
| arc | ||
| atheros | ||
| broadcom | ||
| brocade | ||
| cadence | ||
| calxeda | ||
| chelsio | ||
| cirrus | ||
| cisco | ||
| davicom | ||
| dec | ||
| dlink | ||
| emulex | ||
| faraday | ||
| freescale | ||
| fujitsu | ||
| hisilicon | ||
| hp | ||
| i825xx | ||
| ibm | ||
| icplus | ||
| intel | ||
| marvell | ||
| mellanox | ||
| micrel | ||
| microchip | ||
| moxa | ||
| myricom | ||
| natsemi | ||
| neterion | ||
| nuvoton | ||
| nvidia | ||
| nxp | ||
| octeon | ||
| oki-semi | ||
| packetengines | ||
| pasemi | ||
| qlogic | ||
| rdc | ||
| realtek | ||
| renesas | ||
| samsung | ||
| seeq | ||
| sfc | ||
| sgi | ||
| silan | ||
| sis | ||
| smsc | ||
| stmicro | ||
| sun | ||
| tehuti | ||
| ti | ||
| tile | ||
| toshiba | ||
| tundra | ||
| via | ||
| wiznet | ||
| xilinx | ||
| xircom | ||
| xscale | ||
| dnet.c | ||
| dnet.h | ||
| ec_bhf.c | ||
| ethoc.c | ||
| fealnx.c | ||
| jme.c | ||
| jme.h | ||
| Kconfig | ||
| korina.c | ||
| lantiq_etop.c | ||
| Makefile | ||
| netx-eth.c | ||
| s6gmac.c | ||