forked from Minki/linux
0751d33c27
For IR wakeup, a driver has to program the hardware to wakeup at a specific IR sequence, so it makes no sense to allow multiple wakeup protocols to be selected. In the same manner the sysfs interface only allows one scancode to be provided. In addition, we need to know the specific variant of the protocol. In short, these changes are made to the wakeup_protocols sysfs entry: - list all the protocol variants rather than the protocol groups, e.g. "nec nec-x nec-32" rather than just "nec". - only allow one protocol variant to be selected rather than multiple - wakeup_filter can only be set once a protocol has been selected in wakeup_protocols. This is an API change, however the only user of this API is the img-ir, but the wakeup code was never merged to mainline, so it was never used. Signed-off-by: Sean Young <sean@mess.org> Cc: James Hogan <james.hogan@imgtec.com> Cc: Sifan Naeem <sifan.naeem@imgtec.com> Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com> |
||
|---|---|---|
| .. | ||
| keytable.c.rst | ||
| lirc-dev-intro.rst | ||
| lirc-dev.rst | ||
| lirc-func.rst | ||
| lirc-get-features.rst | ||
| lirc-get-length.rst | ||
| lirc-get-rec-mode.rst | ||
| lirc-get-rec-resolution.rst | ||
| lirc-get-send-mode.rst | ||
| lirc-get-timeout.rst | ||
| lirc-header.rst | ||
| lirc-read.rst | ||
| lirc-set-measure-carrier-mode.rst | ||
| lirc-set-rec-carrier-range.rst | ||
| lirc-set-rec-carrier.rst | ||
| lirc-set-rec-timeout-reports.rst | ||
| lirc-set-rec-timeout.rst | ||
| lirc-set-send-carrier.rst | ||
| lirc-set-send-duty-cycle.rst | ||
| lirc-set-transmitter-mask.rst | ||
| lirc-set-wideband-receiver.rst | ||
| lirc-write.rst | ||
| rc-intro.rst | ||
| rc-sysfs-nodes.rst | ||
| rc-table-change.rst | ||
| rc-tables.rst | ||
| remote_controllers.rst | ||