forked from Minki/linux
948fea37dc
This patch (as1082) makes a small optimization to the way the hub driver carries out port debouncing immediately after a hub is activated (i.e., initialized, reset, or resumed). If any port-change statuses are observed, the code will delay for a minimal debounce period -- thereby making a good start at debouncing all the ports at once. If this wasn't sufficient then khubd will debounce any port that still requires attention. But in most cases it should suffice; it's rare for a device to need more than a minimal debounce delay. (In the cases of hub initialization or reset even that is most likely not needed, since any devices plugged in at such times have probably been attached for a while.) Signed-off-by: Alan Stern <stern@rowland.harvard.edu> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de> |
||
|---|---|---|
| .. | ||
| buffer.c | ||
| config.c | ||
| devices.c | ||
| devio.c | ||
| driver.c | ||
| endpoint.c | ||
| file.c | ||
| generic.c | ||
| hcd-pci.c | ||
| hcd.c | ||
| hcd.h | ||
| hub.c | ||
| hub.h | ||
| inode.c | ||
| Kconfig | ||
| Makefile | ||
| message.c | ||
| notify.c | ||
| otg_whitelist.h | ||
| quirks.c | ||
| sysfs.c | ||
| urb.c | ||
| usb.c | ||
| usb.h | ||