..
acx.c
wlcore: enable beacon filtering only after receiving a beacon
2014-02-13 15:20:16 -05:00
acx.h
wl18xx: move to new firmware (wl18xx-fw-3.bin)
2014-02-13 15:20:15 -05:00
boot.c
wlcore: use single-role version when verifying the PLT firmware
2013-02-08 10:05:01 +02:00
boot.h
cmd.c
wlcore: decrease warning verbosity during recovery
2014-02-13 15:20:16 -05:00
cmd.h
wlcore: increase timeout to 5000 msecs
2014-02-13 15:20:16 -05:00
conf.h
wlcore: fwlog dynamic mem_block control
2013-10-23 09:47:40 +03:00
debug.h
wlcore: use print_hex_dump_debug()
2013-03-25 12:36:24 +02:00
debugfs.c
wlcore: print active channel in the driver_state
2013-10-23 09:47:39 +03:00
debugfs.h
event.c
wlcore/wl12xx/wl18xx: configure num_links per-hw
2014-02-13 15:20:15 -05:00
event.h
wlcore: support scan reports during periodic scan
2012-12-11 12:37:23 +02:00
hw_ops.h
wlcore/wl12xx/wl18xx: simplify fw_status handling
2014-02-13 15:20:15 -05:00
ini.h
init.c
wlcore: enable beacon filtering only after receiving a beacon
2014-02-13 15:20:16 -05:00
init.h
io.c
io.h
wlcore: block read/writes to FW during ELP
2014-02-13 15:20:14 -05:00
Kconfig
Remove GENERIC_HARDIRQ config option
2013-09-13 15:09:52 +02:00
main.c
net: Replace min macro with min_t
2014-03-03 15:35:54 -05:00
Makefile
wlcore: move sysfs handling to a separate file
2013-06-17 11:56:59 +03:00
ps.c
wlcore: AP: don't start mac80211 PS on non-peer HLIDs
2014-02-13 15:20:14 -05:00
ps.h
rx.c
wlcore/wl12xx/wl18xx: configure num_links per-hw
2014-02-13 15:20:15 -05:00
rx.h
wlcore/wl12xx/wl18xx: simplify fw_status handling
2014-02-13 15:20:15 -05:00
scan.c
cfg80211: consolidate passive-scan and no-ibss flags
2013-11-25 20:49:35 +01:00
scan.h
wlcore: support scan reports during periodic scan
2012-12-11 12:37:23 +02:00
sdio.c
wlcore: remove newly introduced alloc/OOM messages
2013-02-11 15:34:58 -05:00
spi.c
net: Replace min macro with min_t
2014-03-03 15:35:54 -05:00
sysfs.c
net: Replace min macro with min_t
2014-03-03 15:35:54 -05:00
sysfs.h
wlcore: move sysfs handling to a separate file
2013-06-17 11:56:59 +03:00
testmode.c
wlcore: fix interrogate command length
2013-10-23 09:47:40 +03:00
testmode.h
mac80211: add vif to testmode cmd
2013-08-12 14:11:42 +02:00
tx.c
wlcore: consider multiple APs when checking active_link_count
2014-02-13 15:20:16 -05:00
tx.h
wlcore: send EAPOL frames with voice priority
2014-02-13 15:20:15 -05:00
wl12xx_80211.h
wlcore_i.h
wl18xx: move to new firmware (wl18xx-fw-3.bin)
2014-02-13 15:20:15 -05:00
wlcore.h
wlcore: wl18xx: allow CCK rates for AP mode
2014-02-13 15:20:16 -05:00