forked from Minki/linux
ce443ab5fd
change from original version -- by advice of Paul Mundt 1. remove videomemorysize definitions 2. remove unifb_enable and unifb_setup 3. use dev_warn instead of printk in fb driver 4. remove judgement for FB_ACCEL_PUV3_UNIGFX 5. adjust clk_get and clk_set_rate calls 6. add resources definitions 7. remove unifb_option 8. adjust register for platform_device 9. adjust unifb_ops position and unifb_regs assignment position Signed-off-by: Guan Xuetao <gxt@mprc.pku.edu.cn> Acked-by: Arnd Bergmann <arnd@arndb.de>
216 lines
4.3 KiB
Plaintext
216 lines
4.3 KiB
Plaintext
### General setup
|
|
CONFIG_EXPERIMENTAL=y
|
|
CONFIG_LOCALVERSION="-debug"
|
|
CONFIG_SWAP=y
|
|
CONFIG_SYSVIPC=y
|
|
CONFIG_POSIX_MQUEUE=y
|
|
CONFIG_HOTPLUG=y
|
|
# Initial RAM filesystem and RAM disk (initramfs/initrd) support
|
|
#CONFIG_BLK_DEV_INITRD=y
|
|
#CONFIG_INITRAMFS_SOURCE="arch/unicore/ramfs/ramfs_config"
|
|
|
|
### Enable loadable module support
|
|
CONFIG_MODULES=n
|
|
CONFIG_MODULE_UNLOAD=y
|
|
|
|
### System Type
|
|
CONFIG_ARCH_PUV3=y
|
|
# Board Selection
|
|
CONFIG_PUV3_NB0916=y
|
|
# Processor Features
|
|
CONFIG_CPU_DCACHE_LINE_DISABLE=y
|
|
CONFIG_CPU_TLB_SINGLE_ENTRY_DISABLE=n
|
|
|
|
### Bus support
|
|
CONFIG_PCI=y
|
|
CONFIG_PCI_LEGACY=n
|
|
|
|
### Boot options
|
|
# for debug, adding: earlyprintk=ocd,keep initcall_debug
|
|
# others support: test_suspend=mem root=/dev/sda
|
|
# hibernate support: resume=/dev/sda3
|
|
CONFIG_CMDLINE="earlyprintk=ocd,keep ignore_loglevel"
|
|
# TODO: mem=512M video=unifb:1024x600-16@75
|
|
# for nfs: root=/dev/nfs rw nfsroot=192.168.10.88:/home/udb/nfs/,rsize=1024,wsize=1024
|
|
# ip=192.168.10.83:192.168.10.88:192.168.10.1:255.255.255.0::eth0:off
|
|
CONFIG_CMDLINE_FORCE=y
|
|
|
|
### Power management options
|
|
CONFIG_PM=y
|
|
CONFIG_HIBERNATION=y
|
|
CONFIG_PM_STD_PARTITION="/dev/sda3"
|
|
CONFIG_CPU_FREQ=n
|
|
CONFIG_CPU_FREQ_DEFAULT_GOV_USERSPACE=y
|
|
|
|
### Networking support
|
|
CONFIG_NET=y
|
|
# Networking options
|
|
CONFIG_PACKET=m
|
|
CONFIG_UNIX=m
|
|
# TCP/IP networking
|
|
CONFIG_INET=y
|
|
CONFIG_IP_MULTICAST=y
|
|
CONFIG_IP_PNP=y
|
|
CONFIG_IPV6=n
|
|
# Wireless
|
|
CONFIG_WIRELESS=y
|
|
CONFIG_WIRELESS_EXT=y
|
|
CONFIG_MAC80211=m
|
|
|
|
### PKUnity SoC Features
|
|
CONFIG_USB_WLAN_HED_AQ3=n
|
|
CONFIG_USB_CMMB_INNOFIDEI=n
|
|
CONFIG_I2C_BATTERY_BQ27200=n
|
|
CONFIG_I2C_EEPROM_AT24=n
|
|
CONFIG_LCD_BACKLIGHT=n
|
|
|
|
CONFIG_PUV3_RTC=y
|
|
CONFIG_PUV3_UMAL=y
|
|
CONFIG_PUV3_MUSB=n
|
|
CONFIG_PUV3_AC97=n
|
|
CONFIG_PUV3_NAND=n
|
|
CONFIG_PUV3_MMC=n
|
|
CONFIG_PUV3_UART=n
|
|
|
|
### Device Drivers
|
|
# Memory Technology Device (MTD) support
|
|
CONFIG_MTD=m
|
|
CONFIG_MTD_UBI=m
|
|
CONFIG_MTD_PARTITIONS=y
|
|
CONFIG_MTD_CHAR=m
|
|
CONFIG_MTD_BLKDEVS=m
|
|
# RAM/ROM/Flash chip drivers
|
|
CONFIG_MTD_CFI=m
|
|
CONFIG_MTD_JEDECPROBE=m
|
|
CONFIG_MTD_CFI_AMDSTD=m
|
|
# Mapping drivers for chip access
|
|
CONFIG_MTD_PHYSMAP=m
|
|
|
|
# Block devices
|
|
CONFIG_BLK_DEV_LOOP=m
|
|
|
|
# SCSI device support
|
|
CONFIG_SCSI=y
|
|
CONFIG_BLK_DEV_SD=y
|
|
CONFIG_BLK_DEV_SR=m
|
|
CONFIG_CHR_DEV_SG=m
|
|
|
|
# Serial ATA (prod) and Parallel ATA (experimental) drivers
|
|
CONFIG_ATA=y
|
|
CONFIG_SATA_VIA=y
|
|
|
|
# Network device support
|
|
CONFIG_NETDEVICES=y
|
|
CONFIG_NET_ETHERNET=y
|
|
CONFIG_NETDEV_1000=y
|
|
# Wireless LAN
|
|
CONFIG_WLAN_80211=n
|
|
CONFIG_RT2X00=n
|
|
CONFIG_RT73USB=n
|
|
|
|
# Input device support
|
|
CONFIG_INPUT_EVDEV=m
|
|
# Keyboards
|
|
CONFIG_KEYBOARD_GPIO=m
|
|
|
|
# I2C support
|
|
CONFIG_I2C=y
|
|
CONFIG_I2C_PUV3=y
|
|
|
|
# Hardware Monitoring support
|
|
#CONFIG_SENSORS_LM75=m
|
|
# Generic Thermal sysfs driver
|
|
#CONFIG_THERMAL=m
|
|
#CONFIG_THERMAL_HWMON=y
|
|
|
|
# Multimedia support
|
|
CONFIG_MEDIA_SUPPORT=n
|
|
CONFIG_VIDEO_DEV=n
|
|
CONFIG_USB_VIDEO_CLASS=n
|
|
|
|
# Graphics support
|
|
CONFIG_FB=y
|
|
CONFIG_FB_PUV3_UNIGFX=y
|
|
# Console display driver support
|
|
CONFIG_VGA_CONSOLE=n
|
|
CONFIG_FRAMEBUFFER_CONSOLE=y
|
|
CONFIG_FONTS=y
|
|
CONFIG_FONT_8x8=y
|
|
CONFIG_FONT_8x16=y
|
|
# Bootup logo
|
|
CONFIG_LOGO=n
|
|
|
|
# Sound card support
|
|
CONFIG_SOUND=m
|
|
# Advanced Linux Sound Architecture
|
|
CONFIG_SND=m
|
|
CONFIG_SND_MIXER_OSS=m
|
|
CONFIG_SND_PCM_OSS=m
|
|
|
|
# USB support
|
|
CONFIG_USB_ARCH_HAS_HCD=n
|
|
CONFIG_USB=n
|
|
CONFIG_USB_DEVICEFS=n
|
|
CONFIG_USB_PRINTER=n
|
|
CONFIG_USB_STORAGE=n
|
|
# Inventra Highspeed Dual Role Controller
|
|
CONFIG_USB_MUSB_HDRC=n
|
|
|
|
# LED Support
|
|
CONFIG_NEW_LEDS=y
|
|
CONFIG_LEDS_CLASS=y
|
|
CONFIG_LEDS_GPIO=y
|
|
# LED Triggers
|
|
CONFIG_LEDS_TRIGGERS=y
|
|
CONFIG_LEDS_TRIGGER_TIMER=y
|
|
CONFIG_LEDS_TRIGGER_IDE_DISK=y
|
|
CONFIG_LEDS_TRIGGER_HEARTBEAT=y
|
|
|
|
# Real Time Clock
|
|
CONFIG_RTC_LIB=m
|
|
CONFIG_RTC_CLASS=m
|
|
|
|
### File systems
|
|
CONFIG_EXT2_FS=m
|
|
CONFIG_EXT3_FS=y
|
|
CONFIG_EXT4_FS=y
|
|
CONFIG_FUSE_FS=m
|
|
# CD-ROM/DVD Filesystems
|
|
CONFIG_ISO9660_FS=m
|
|
CONFIG_JOLIET=y
|
|
CONFIG_UDF_FS=m
|
|
# DOS/FAT/NT Filesystems
|
|
CONFIG_VFAT_FS=m
|
|
# Pseudo filesystems
|
|
CONFIG_PROC_FS=y
|
|
CONFIG_SYSFS=y
|
|
CONFIG_TMPFS=y
|
|
# Miscellaneous filesystems
|
|
CONFIG_MISC_FILESYSTEMS=y
|
|
CONFIG_JFFS2_FS=m
|
|
CONFIG_UBIFS_FS=m
|
|
# Network File Systems
|
|
CONFIG_NETWORK_FILESYSTEMS=y
|
|
CONFIG_NFS_FS=y
|
|
CONFIG_NFS_V3=y
|
|
CONFIG_ROOT_NFS=y
|
|
# Partition Types
|
|
CONFIG_PARTITION_ADVANCED=y
|
|
CONFIG_MSDOS_PARTITION=y
|
|
# Native language support
|
|
CONFIG_NLS=y
|
|
CONFIG_NLS_CODEPAGE_437=m
|
|
CONFIG_NLS_CODEPAGE_936=m
|
|
CONFIG_NLS_ISO8859_1=m
|
|
CONFIG_NLS_UTF8=m
|
|
|
|
### Kernel hacking
|
|
CONFIG_FRAME_WARN=8096
|
|
CONFIG_MAGIC_SYSRQ=y
|
|
CONFIG_DEBUG_KERNEL=y
|
|
CONFIG_PROVE_LOCKING=n
|
|
CONFIG_DEBUG_BUGVERBOSE=y
|
|
CONFIG_FRAME_POINTER=y
|
|
CONFIG_DEBUG_LL=y
|
|
|