forked from Minki/linux
ed520c90b3
Update all the Tegra DT bindings to require the standard dmas/dma-names properties rather than non-standard nvidia,dma-request-selector property. This is a DT-ABI-incompatible change. It is the second of two changes required for me to consider the Tegra DT bindings as stable, the other being the previous conversion to the common reset bindings. Signed-off-by: Stephen Warren <swarren@nvidia.com>
38 lines
1.2 KiB
Plaintext
38 lines
1.2 KiB
Plaintext
NVIDIA Tegra20/Tegra30 high speed (DMA based) UART controller driver.
|
|
|
|
Required properties:
|
|
- compatible : should be "nvidia,tegra30-hsuart", "nvidia,tegra20-hsuart".
|
|
- reg: Should contain UART controller registers location and length.
|
|
- interrupts: Should contain UART controller interrupts.
|
|
- clocks: Must contain one entry, for the module clock.
|
|
See ../clocks/clock-bindings.txt for details.
|
|
- resets : Must contain an entry for each entry in reset-names.
|
|
See ../reset/reset.txt for details.
|
|
- reset-names : Must include the following entries:
|
|
- serial
|
|
- dmas : Must contain an entry for each entry in clock-names.
|
|
See ../dma/dma.txt for details.
|
|
- dma-names : Must include the following entries:
|
|
- rx
|
|
- tx
|
|
|
|
Optional properties:
|
|
- nvidia,enable-modem-interrupt: Enable modem interrupts. Should be enable
|
|
only if all 8 lines of UART controller are pinmuxed.
|
|
|
|
Example:
|
|
|
|
serial@70006000 {
|
|
compatible = "nvidia,tegra30-hsuart", "nvidia,tegra20-hsuart";
|
|
reg = <0x70006000 0x40>;
|
|
reg-shift = <2>;
|
|
interrupts = <0 36 0x04>;
|
|
nvidia,enable-modem-interrupt;
|
|
clocks = <&tegra_car 6>;
|
|
resets = <&tegra_car 6>;
|
|
reset-names = "serial";
|
|
dmas = <&apbdma 8>, <&apbdma 8>;
|
|
dma-names = "rx", "tx";
|
|
status = "disabled";
|
|
};
|