forked from Minki/linux
0331bbf3c6
Generic bindings for RS485 feature included in some UARTs. Those bindings have to be used withing an UART device tree node. Documentation updated to link to the bindings definition. Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com> Acked-by: Grant Likely <grant.likely@secretlab.ca> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
32 lines
1.1 KiB
Plaintext
32 lines
1.1 KiB
Plaintext
* RS485 serial communications
|
|
|
|
The RTS signal is capable of automatically controlling line direction for
|
|
the built-in half-duplex mode.
|
|
The properties described hereafter shall be given to a half-duplex capable
|
|
UART node.
|
|
|
|
Required properties:
|
|
- rs485-rts-delay: prop-encoded-array <a b> where:
|
|
* a is the delay beteween rts signal and beginning of data sent in milliseconds.
|
|
it corresponds to the delay before sending data.
|
|
* b is the delay between end of data sent and rts signal in milliseconds
|
|
it corresponds to the delay after sending data and actual release of the line.
|
|
|
|
Optional properties:
|
|
- linux,rs485-enabled-at-boot-time: empty property telling to enable the rs485
|
|
feature at boot time. It can be disabled later with proper ioctl.
|
|
- rs485-rx-during-tx: empty property that enables the receiving of data even
|
|
whilst sending data.
|
|
|
|
RS485 example for Atmel USART:
|
|
usart0: serial@fff8c000 {
|
|
compatible = "atmel,at91sam9260-usart";
|
|
reg = <0xfff8c000 0x4000>;
|
|
interrupts = <7>;
|
|
atmel,use-dma-rx;
|
|
atmel,use-dma-tx;
|
|
linux,rs485-enabled-at-boot-time;
|
|
rs485-rts-delay = <0 200>; // in milliseconds
|
|
};
|
|
|