Paul Mundt 61a46766c9 sh: pci: Support slot 4 routing on SDK7786. ... SDK7786 supports connecting either slot3 or 4 to the same PCIe port by way of FPGA muxing. By default the vertical slot 3 on the baseboard is enabled, so this adds in a command line option for forcibly enabling the slot 4 edge connector. If nothing has been specified on the command line, we fall back to reading the resistor values for card presence to figure out where to route the port to. Signed-off-by: Paul Mundt <lethal@linux-sh.org>		2010-10-14 07:37:01 +09:00
..
asm	sh: wire up perf alignment and emulation faults.	2010-10-13 06:55:26 +09:00
cpu-common/cpu	sh: Kill off unused cpu/cacheflush.h.	2009-08-21 16:20:57 +09:00
cpu-sh2/cpu	sh: Mass ctrl_in/outX to __raw_read/writeX conversion.	2010-01-26 12:58:40 +09:00
cpu-sh2a/cpu	sh: Convert SH-2A to new cacheflush interface.	2009-08-15 12:38:29 +09:00
cpu-sh3/cpu	sh: Fix up the SH-3 build.	2010-10-07 02:57:39 +09:00
cpu-sh4/cpu	sh: pinmux support for SH-X3 proto CPUs.	2010-10-02 19:20:51 +09:00
cpu-sh5/cpu	sh: Convert cache disabled SH-5 over to new cache interface.	2009-08-16 00:53:56 +09:00
mach-common/mach	sh: SH-2007 board support.	2010-06-21 15:10:51 +09:00
mach-dreamcast/mach	sh: mach-dreamcast: Convert to sparseirq.	2010-02-02 18:01:55 +09:00
mach-ecovec24/mach	sh: add romImage MMCIF boot for sh7724 and Ecovec V2	2010-05-31 13:11:54 +09:00
mach-kfr2r09/mach	sh: add a parameter to LCDC driver's .display_on() callback	2010-08-04 16:12:11 +09:00
mach-landisk/mach
mach-migor/mach	sh: audio support for the sh7722 Migo-R board	2010-03-02 11:08:54 +09:00
mach-sdk7786/mach	sh: pci: Support slot 4 routing on SDK7786.	2010-10-14 07:37:01 +09:00
mach-se/mach	sh: mach-se: Convert SE7343 FPGA to dynamic IRQ allocation.	2010-01-12 13:37:04 +09:00
mach-sh03/mach
mach-x3proto/mach	sh: mach-x3proto: Support for baseboard GPIOs.	2010-10-04 02:59:29 +09:00