linux/drivers/scsi/ufs
Subhash Jadavani 57d104c153 ufs: add UFS power management support
This patch adds support for UFS device and UniPro link power management
during runtime/system PM.

Main idea is to define multiple UFS low power levels based on UFS device
and UFS link power states. This would allow any specific platform or pci
driver to choose the best suited low power level during runtime and
system suspend based on their power goals.

bkops handlig:
To put the UFS device in sleep state when bkops is disabled, first query
the bkops status from the device and enable bkops on device only if
device needs time to perform the bkops.

START_STOP handling:
Before sending START_STOP_UNIT to the device well-known logical unit
(w-lun) to make sure that the device w-lun unit attention condition is
cleared.

Write protection:
UFS device specification allows LUs to be write protected, either
permanently or power on write protected. If any LU is power on write
protected and if the card is power cycled (by powering off VCCQ and/or
VCC rails), LU's write protect status would be lost. So this means those
LUs can be written now. To ensures that UFS device is power cycled only
if the power on protect is not set for any of the LUs, check if power on
write protect is set and if device is in sleep/power-off state & link in
inactive state (Hibern8 or OFF state).
If none of the Logical Units on UFS device is power on write protected
then all UFS device power rails (VCC, VCCQ & VCCQ2) can be turned off if
UFS device is in power-off state and UFS link is in OFF state. But current
implementation would disable all device power rails even if UFS link is
not in OFF state.

Low power mode:
If UFS link is in OFF state then UFS host controller can be power collapsed
to avoid leakage current from it. Note that if UFS host controller is power
collapsed, full UFS reinitialization will be required on resume to
re-establish the link between host and device.

Signed-off-by: Subhash Jadavani <subhashj@codeaurora.org>
Signed-off-by: Dolev Raviv <draviv@codeaurora.org>
Signed-off-by: Sujit Reddy Thumma <sthumma@codeaurora.org>
Signed-off-by: Christoph Hellwig <hch@lst.de>
2014-10-01 13:11:23 +02:00
..
Kconfig [SCSI] ufs: SCSI_UFSHCD should depend on SCSI_DMA 2013-06-04 11:16:20 -07:00
Makefile [SCSI] ufs: Add Platform glue driver for ufshcd 2013-05-02 16:16:50 -07:00
ufs.h ufs: add UFS power management support 2014-10-01 13:11:23 +02:00
ufshcd-pci.c ufs: add UFS power management support 2014-10-01 13:11:23 +02:00
ufshcd-pltfrm.c ufs: add UFS power management support 2014-10-01 13:11:23 +02:00
ufshcd.c ufs: add UFS power management support 2014-10-01 13:11:23 +02:00
ufshcd.h ufs: add UFS power management support 2014-10-01 13:11:23 +02:00
ufshci.h ufs: add UFS power management support 2014-10-01 13:11:23 +02:00
unipro.h [SCSI] ufs: configure the attribute for power mode 2013-09-06 16:08:37 -07:00