leandrof/linux
1
0
Fork 0
forked from Minki/linux
Code Issues Pull Requests Packages Projects Releases Wiki Activity
52b9e6eb07
linux/drivers/usb/musb
History
Felipe Balbi 52b9e6eb07 usb: musb: dsps: remove babble check from dsps irq handler 
musb->int_usb already contains the correct
information for musb-core to handle babble.

In fact, this very check was just causing a
nonsensical babble interrupt storm.

With this I can get test.sh to run and, even though
all tests fail with timeout, that's still better
than locking up the system due to IRQ storm.

Also, if I remove g_zero and load g_mass_storage,
then everything works fine again.

Tested-by: Bin Liu <b-liu@ti.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
2015-03-10 15:33:26 -05:00
..
am35x.c usb: musb: Change end point selection to use new IO access 2014-11-25 08:47:06 -06:00
blackfin.c usb: musb: blackfin: remove incorrect __exit_p() 2015-02-02 13:04:55 -06:00
blackfin.h
cppi_dma.c usb: musb: dma: merge ->start/stop into create/destroy 2013-07-29 13:53:18 +03:00
cppi_dma.h
da8xx.c usb: musb: Pass fifo_mode in platform data 2014-11-25 08:47:07 -06:00
davinci.c usb: move the OTG state from the USB PHY to the OTG structure 2014-11-03 10:01:25 -06:00
davinci.h
jz4740.c usb: musb: Pass fifo_mode in platform data 2014-11-25 08:47:07 -06:00
Kconfig usb: musb: add omap-control dependency 2015-01-29 10:36:29 -06:00
Makefile usb: musb: add support for JZ4740 usb device controller 2013-12-20 09:53:24 -06:00
musb_am335x.c usb: musb: Fix panic upon musb_am335x module removal 2014-06-27 10:53:06 -05:00
musb_core.c usb: musb: dsps: remove babble check from dsps irq handler 2015-03-10 15:33:26 -05:00
musb_core.h usb: musb: Use IS_ENABLED for tusb6010 2014-11-25 08:47:07 -06:00
musb_cppi41.c usb: musb: cppi41: improve rx channel abort routine 2015-01-27 09:34:58 -06:00
musb_debug.h
musb_debugfs.c Linux 3.19-rc5 2015-01-19 09:57:20 -06:00
musb_dma.h usb: musb: introduce dma_channel.rx_packet_done 2014-06-30 14:26:24 -05:00
musb_dsps.c usb: musb: dsps: remove babble check from dsps irq handler 2015-03-10 15:33:26 -05:00
musb_gadget_ep0.c usb: musb: gadget: use common is_selfpowered 2015-01-29 10:35:43 -06:00
musb_gadget.c usb: musb: gadget: get rid of stop_activity() 2015-03-09 10:38:48 -05:00
musb_gadget.h
musb_host.c usb: musb: musb_host: Enable HCD_BH flag to handle urb return in bottom half 2015-02-23 00:04:52 -06:00
musb_host.h usb: musb: fix prototype for musb_port_reset 2013-12-20 15:05:43 -06:00
musb_io.h usb: musb: Change end point selection to use new IO access 2014-11-25 08:47:06 -06:00
musb_regs.h usb: musb: Use IS_ENABLED for tusb6010 2014-11-25 08:47:07 -06:00
musb_virthub.c usb: musb: fix device hotplug behind hub 2015-02-04 11:16:47 -06:00
musbhsdma.c usb: musb: Change end point selection to use new IO access 2014-11-25 08:47:06 -06:00
musbhsdma.h
omap2430.c usb: musb: Fix use for of_property_read_bool for disabled multipoint 2015-02-23 09:14:30 -06:00
omap2430.h
tusb6010_omap.c usb: musb: tusb6010: Use musb->tusb_revision instead of tusb_get_revision call. 2014-05-16 12:16:31 -05:00
tusb6010.c usb: musb: Change end point selection to use new IO access 2014-11-25 08:47:06 -06:00
tusb6010.h usb: musb: tusb6010: Use musb->tusb_revision instead of tusb_get_revision call. 2014-05-16 12:16:31 -05:00
ux500_dma.c usb: musb: Change to use new IO access 2014-11-25 08:47:06 -06:00
ux500.c usb: musb: Pass fifo_mode in platform data 2014-11-25 08:47:07 -06:00