forked from Minki/linux
98cd1552ea
This patch adds support for a DSA mock-up driver which essentially does the following: - registers/unregisters 4 fixed PHYs to the slave network devices - uses eth0 (configurable) as the master netdev - registers the switch as a fixed MDIO device against the fixed MDIO bus at address 31 - includes dynamic debug prints for dsa_switch_ops functions that can be enabled to get call traces This is a good way to test modular builds as well as exercise the DSA APIs without requiring access to real hardware. This does not test the data-path, although this could be added later on. Signed-off-by: Florian Fainelli <f.fainelli@gmail.com> Signed-off-by: David S. Miller <davem@davemloft.net>
8 lines
270 B
Makefile
8 lines
270 B
Makefile
obj-$(CONFIG_NET_DSA_MV88E6060) += mv88e6060.o
|
|
obj-$(CONFIG_NET_DSA_BCM_SF2) += bcm-sf2.o
|
|
bcm-sf2-objs := bcm_sf2.o bcm_sf2_cfp.o
|
|
obj-$(CONFIG_NET_DSA_QCA8K) += qca8k.o
|
|
obj-y += b53/
|
|
obj-y += mv88e6xxx/
|
|
obj-$(CONFIG_NET_DSA_LOOP) += dsa_loop.o dsa_loop_bdinfo.o
|