forked from Minki/linux
339fd36238
drm_kms_helper_poll_enable_locked() should check if we have delayed event pending and if we have, schedule the work to run without delay. Currently the output_poll_work is only scheduled if any of the connectors have DRM_CONNECTOR_POLL_CONNECT or DRM_CONNECTOR_POLL_DISCONNECT with DRM_OUTPUT_POLL_PERIOD delay. It does not matter if we have delayed event already registered to be handled. The detection will be delayd by DRM_OUTPUT_POLL_PERIOD in any case. Furthermore if none of the connectors are marked as POLL_CONNECT or POLL_DISCONNECT because all connectors are either POLL_HPD or they are always connected: the output_poll_work will not run at all even if we have delayed event marked. When none of the connectors require polling, their initial status change from unknown to connected/disconnected is not going to be handled until the first kms application starts or if we have fb console enabled. Note that in general the output poll work should be enabled already when this happens, but at driver load usually the first probe happens before the output polling is enabled. This patch fixes this case. Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com> [danvet: Note when exactly this is an issue, since the probe code schedules the poll work itself already.] Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch> Link: http://patchwork.freedesktop.org/patch/msgid/20160831110905.31289-1-peter.ujfalusi@ti.com |
||
|---|---|---|
| .. | ||
| drm | ||
| host1x | ||
| ipu-v3 | ||
| vga | ||
| Makefile | ||