forked from Minki/linux
7c2ce6e60f
This patch adds support for adaptive interrupt coalescing. For small pkts with low pkt rate, we can decrease the coalescing interrupt dynamically which decreases the latency. This however increases the cpu utilization. Based on testing with different coal intr and pkt rate we came up with a table(mod_table) with rx_rate and coalescing interrupt value where we get low latency without significant increase in cpu. mod_table table stores the coalescing timer percentage value for different throughputs. Function enic_calc_int_moderation() calculates the desired coalescing intr timer value. This function is called in driver rx napi_poll. The actual value is set by enic_set_int_moderation() which is called when napi_poll is complete. i.e when we unmask the rx intr. Adaptive coal intr is support only when driver is using msix intr. Because intr is not shared. Struct mod_range is used to store only the default adaptive coalescing intr value. Adaptive coal intr calue is calculated by timer = range_start + ((rx_coal->range_end - range_start) * mod_table[index].range_percent / 100); rx_coal->range_end is the rx-usecs-high value set using ethtool. range_start is rx-usecs-low, set using ethtool, if rx_small_pkt_bytes_cnt is greater than 2 * rx_large_pkt_bytes_cnt. i.e small pkts are dominant. Else its rx-usecs-low + 3. Cc: Christian Benvenuti <benve@cisco.com> Cc: Neel Patel <neepatel@cisco.com> Signed-off-by: Sujith Sankar <ssujith@cisco.com> Signed-off-by: Govindarajulu Varadarajan <_govind@gmx.com> Signed-off-by: David S. Miller <davem@davemloft.net> |
||
|---|---|---|
| .. | ||
| enic | ||
| Kconfig | ||
| Makefile | ||