forked from Minki/linux
2a4cfd1022
When trying to play a 8kHz file with codec in slave mode we get the following error on a mx28evk: $ aplay -Dhw:0,0 stereo_8k.wav Playing WAVE 'stereo_8k.wav' : Signed 16 bit Little Endian, Rate 8000 Hz, Stereo [ 21.218647] sgtl5000 0-000a: PLL not supported in slave mode [ 21.224559] sgtl5000 0-000a: 128 ratio is not supported. SYS_MCLK needs to be 256, 384 or 512 * fs [ 21.233687] sgtl5000 0-000a: ASoC: can't set sgtl5000 hw params: -22 aplay: set_params:1123: Unable to install hw params: This error happens because we are using 'sys_fs' instead of 'frame_rate' in the valid ratio check. Use the real'frame_rate' so that the ratio is correctly calculated and the playback can run. sgtl5000 codec manual states that in 'Synchronous SYS_MCLK input' mode that the following SYS_CLK frequencies are allowed: 256*fs, 384*fs, 512*fs. , where fs is the sampling frequency, which can be in the range of: 8, 11.025, 16, 22.5, 32, 44.1, 48, 96 kHz. Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com> Signed-off-by: Mark Brown <broonie@kernel.org> |
||
|---|---|---|
| .. | ||
| aoa | ||
| arm | ||
| atmel | ||
| core | ||
| drivers | ||
| firewire | ||
| i2c | ||
| isa | ||
| mips | ||
| oss | ||
| parisc | ||
| pci | ||
| pcmcia | ||
| ppc | ||
| sh | ||
| soc | ||
| sparc | ||
| spi | ||
| synth | ||
| usb | ||
| ac97_bus.c | ||
| Kconfig | ||
| last.c | ||
| Makefile | ||
| sound_core.c | ||
| sound_firmware.c | ||