linux/drivers/net/wireless/ath/ath9k
Felix Fietkau affad456f2 ath9k: make some hardware reset log messages debug-only
On some chips, baseband watchdog hangs are more common than others, and
the driver has support for handling them.
Interrupts even after a watchdog hang are also quite common, so there's
not much point in spamming the user's logfiles.

Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
2014-02-24 15:38:39 -05:00
..
ahb.c wireless: ath9k: use dev_get_platdata() 2013-09-26 15:13:38 -04:00
ani.c ath9k_hw: remove direct accesses to channel mode flags 2013-10-14 13:39:58 -04:00
ani.h ath9k: Remove unused ANI commands 2013-08-28 13:58:27 -04:00
antenna.c ath9k: add support for reporting per-chain signal strength 2013-12-18 15:23:19 -05:00
ar953x_initvals.h ath9k: Add QCA953x initvals 2014-01-03 15:37:00 -05:00
ar955x_1p0_initvals.h ath9k: Remove AR955x INI duplicates 2013-12-09 15:37:57 -05:00
ar5008_initvals.h ath9k: fix column header comments for some initval arrays 2013-01-07 15:16:53 -05:00
ar5008_phy.c ath9k_hw: remove references to hw->conf 2013-10-14 13:39:59 -04:00
ar9001_initvals.h ath9k: fix column header comments for some initval arrays 2013-01-07 15:16:53 -05:00
ar9002_calib.c ath9k_hw: remove IS_CHAN_B() 2013-10-14 13:39:58 -04:00
ar9002_hw.c ath9k: Register supported HW hang checks 2014-01-03 15:36:57 -05:00
ar9002_initvals.h ath9k: Enable WoW only for AR9462 2013-06-03 15:55:46 -04:00
ar9002_mac.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2014-01-06 14:08:41 -05:00
ar9002_phy.c ath9k_hw: simplify spur channel handling 2013-12-18 15:23:27 -05:00
ar9002_phy.h ath9k: Program HW for WB195 diversity 2013-08-05 14:52:43 -04:00
ar9003_2p2_initvals.h ath9k: Update high power gain table for AR9300 2013-12-09 15:37:59 -05:00
ar9003_buffalo_initvals.h ath9k: Use a separate TX gain table for WZR-HP-G450H 2013-12-09 15:37:58 -05:00
ar9003_calib.c ath9k: Calculate IQ-CAL median 2014-02-12 15:36:08 -05:00
ar9003_eeprom.c ath9k: Fix TX power calculation 2014-02-04 15:30:07 -05:00
ar9003_eeprom.h ath9k: Update BaseExtension_1 eeprom structure 2013-12-18 15:23:44 -05:00
ar9003_hw.c ath9k: Initialize QCA953x INI arrays 2014-01-03 15:37:00 -05:00
ar9003_mac.c ath9k: move ath9k_debug_sync_cause out of ath9k_hw 2013-12-19 14:41:56 -05:00
ar9003_mac.h
ar9003_mci.c ath9k: Use bitops for calibration flags 2013-09-26 15:13:47 -04:00
ar9003_mci.h
ar9003_paprd.c ath9k_hw: fix PA predistortion miscalibration 2013-05-29 15:22:42 -04:00
ar9003_phy.c ath9k: do not set half/quarter channel flags in AR_PHY_MODE 2014-02-24 15:38:38 -05:00
ar9003_phy.h ath9k: Fix regulatory compliance 2014-01-03 15:37:01 -05:00
ar9003_rtt.c ath9k: Fix PeakDetect calibration for AR9462 2013-09-26 15:13:47 -04:00
ar9003_rtt.h
ar9003_wow.c ath9k: Fix wow.c compilation 2013-12-02 14:24:53 -05:00
ar9330_1p1_initvals.h ath9k: Update AR9331 v1.1 initvals 2013-12-09 15:37:57 -05:00
ar9330_1p2_initvals.h ath9k: Update AR9331 v1.2 initvals 2013-12-09 15:37:58 -05:00
ar9340_initvals.h ath9k: Add initval arrays for DFS channels 2013-12-09 15:37:56 -05:00
ar9462_2p0_initvals.h ath9k: Identify duplicate AR9462 v2.0 initvals 2013-12-09 15:37:59 -05:00
ar9462_2p1_initvals.h ath9k: Remove duplicate initvals for AR9462 v2.1 2013-12-02 14:25:02 -05:00
ar9485_initvals.h ath9k: Identify duplicate AR9485 initvals 2013-12-09 15:37:59 -05:00
ar9565_1p0_initvals.h ath9k: Identify duplicate AR9565 v1.0 initvals 2013-12-09 15:38:00 -05:00
ar9565_1p1_initvals.h ath9k: Add initvals for AR9565 1.1 2013-12-02 14:25:01 -05:00
ar9580_1p0_initvals.h ath9k: Add initval arrays for DFS channels 2013-12-09 15:37:56 -05:00
ath9k.h ath9k: Remove ath9k rate control 2014-02-12 15:36:04 -05:00
beacon.c ath9k: prepare for multi-interface CSA support 2014-02-12 15:31:48 -05:00
btcoex.c ath9k_hw: clean up generic timer code 2013-12-18 15:23:22 -05:00
btcoex.h ath9k: stomp audio profiles on weak signal strength 2012-11-21 14:16:01 -05:00
calib.c ath9k: add noise floor parameter to ath9k_hw_getchan_noise 2013-10-18 14:03:53 -04:00
calib.h ath9k: add noise floor parameter to ath9k_hw_getchan_noise 2013-10-18 14:03:53 -04:00
common.c ath9k: move ath9k_rx_skb_postprocess to common.c 2014-02-12 15:36:01 -05:00
common.h ath9k: move ath9k_rx_skb_postprocess to common.c 2014-02-12 15:36:01 -05:00
debug_sta.c ath9k: Fix error reported by smatch 2014-01-16 14:55:41 -05:00
debug.c ath9k: Use static const 2014-02-24 15:38:38 -05:00
debug.h ath9k: Remove ath9k rate control 2014-02-12 15:36:04 -05:00
dfs_debug.c ath9k: dfs_debug fix possible NULL dereference 2013-11-11 14:42:43 -05:00
dfs_debug.h ath9k: Remove ath9k rate control 2014-02-12 15:36:04 -05:00
dfs.c ath9k: add support for reporting per-chain signal strength 2013-12-18 15:23:19 -05:00
dfs.h ath9k/ath: move dfs pattern detector to ath 2013-10-18 14:03:54 -04:00
eeprom_4k.c ath9k_hw: simplify spur channel handling 2013-12-18 15:23:27 -05:00
eeprom_9287.c ath9k_hw: simplify spur channel handling 2013-12-18 15:23:27 -05:00
eeprom_def.c ath9k_hw: simplify spur channel handling 2013-12-18 15:23:27 -05:00
eeprom.c ath9k: allow to load EEPROM content via firmware API 2012-12-10 15:49:57 -05:00
eeprom.h ath9k: use 'struct ath_hw *' as the first argument for 'ath9k_hw_nvram_read' 2012-12-10 15:49:56 -05:00
gpio.c ath9k_hw: clean up generic timer code 2013-12-18 15:23:22 -05:00
hif_usb.c ath9k_htc: Add device ID for Buffalo WLI-UV-AG300P 2014-02-12 15:36:04 -05:00
hif_usb.h
htc_drv_beacon.c ath9k_hw: clean up station beacon timer API 2013-12-18 15:23:32 -05:00
htc_drv_debug.c ath9k: replace snprintf() with scnprintf() 2013-09-26 15:13:35 -04:00
htc_drv_gpio.c ath9k_htc: reconfigure led_gpios after resume 2013-12-18 15:23:02 -05:00
htc_drv_init.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2014-02-13 14:43:02 -05:00
htc_drv_main.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2014-02-13 14:43:02 -05:00
htc_drv_txrx.c ath9k_htc: remove useless memcpy 2014-02-12 15:36:02 -05:00
htc_hst.c ath9k_htc: catch fw panic pattern 2014-02-12 15:36:03 -05:00
htc_hst.h ath9k_htc: catch fw panic pattern 2014-02-12 15:36:03 -05:00
htc.h Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2014-02-13 14:43:02 -05:00
hw-ops.h ath9k: Move private HW callbacks to hw-ops.h 2014-01-03 15:36:58 -05:00
hw.c Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless 2014-02-13 14:43:02 -05:00
hw.h ath9k: Fix RX interrupt mitigation 2014-01-23 14:02:45 -05:00
init.c ath9k: Enable U-APSD AP mode support 2014-02-24 15:21:54 -05:00
Kconfig ath9k: Remove ath9k rate control 2014-02-12 15:36:04 -05:00
link.c ath9k: Fix "cc_lock" usage 2014-01-03 15:36:58 -05:00
mac.c ath9k: Fix baseband watchdog interrupts 2014-01-03 15:36:57 -05:00
mac.h ath9k_htc: use ath9k_cmn_process_rssi 2014-02-12 15:35:59 -05:00
main.c ath9k: make some hardware reset log messages debug-only 2014-02-24 15:38:39 -05:00
Makefile ath9k: Remove ath9k rate control 2014-02-12 15:36:04 -05:00
mci.c ath9k_hw: use a software timer for btcoex no_stomp_timer 2013-12-18 15:23:21 -05:00
mci.h
pci.c ath9k: Update WB335 PCI IDs 2014-01-09 10:56:40 -05:00
phy.h ath9k: Fix diversity combining for AR9285 2013-07-24 11:02:39 -04:00
recv.c ath9k: move ath9k_rx_skb_postprocess to common.c 2014-02-12 15:36:01 -05:00
reg.h ath9k: Add version/revision macros for QCA9531 2014-01-03 15:37:00 -05:00
spectral.c ath9k: fix sparse non static symbol warning 2014-01-03 15:36:56 -05:00
spectral.h ath9k: Cleanup spectral scan code 2013-12-18 15:23:37 -05:00
tx99.c ath9k: initialize retry chain flags in tx99 code 2013-12-11 10:56:22 -05:00
wmi.c
wmi.h ath9k: mark wmi_event_swba as __packed 2013-09-26 15:13:48 -04:00
wow.c ath9k: Remove RX Poll 2014-01-03 15:36:58 -05:00
xmit.c ath9k: prepare for multi-interface CSA support 2014-02-12 15:31:48 -05:00