forked from Minki/linux
659d73ada5
As gpio chips get registered, a device tree node which represents the gpio chip is searched and attached to it. A translate function is also provided to convert the gpio specifier into actual platform settings for pin function selection, pull up/down and driver strength settings. Signed-off-by: Thomas Abraham <thomas.abraham@linaro.org> Acked-by: Grant Likely <grant.likely@secretlab.ca> [kgene.kim@samsung.com: fixed build error] Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
41 lines
1.1 KiB
Plaintext
41 lines
1.1 KiB
Plaintext
Samsung Exynos4 GPIO Controller
|
|
|
|
Required properties:
|
|
- compatible: Compatible property value should be "samsung,exynos4-gpio>".
|
|
|
|
- reg: Physical base address of the controller and length of memory mapped
|
|
region.
|
|
|
|
- #gpio-cells: Should be 4. The syntax of the gpio specifier used by client nodes
|
|
should be the following with values derived from the SoC user manual.
|
|
<[phandle of the gpio controller node]
|
|
[pin number within the gpio controller]
|
|
[mux function]
|
|
[pull up/down]
|
|
[drive strength]>
|
|
|
|
Values for gpio specifier:
|
|
- Pin number: is a value between 0 to 7.
|
|
- Pull Up/Down: 0 - Pull Up/Down Disabled.
|
|
1 - Pull Down Enabled.
|
|
3 - Pull Up Enabled.
|
|
- Drive Strength: 0 - 1x,
|
|
1 - 3x,
|
|
2 - 2x,
|
|
3 - 4x
|
|
|
|
- gpio-controller: Specifies that the node is a gpio controller.
|
|
- #address-cells: should be 1.
|
|
- #size-cells: should be 1.
|
|
|
|
Example:
|
|
|
|
gpa0: gpio-controller@11400000 {
|
|
#address-cells = <1>;
|
|
#size-cells = <1>;
|
|
compatible = "samsung,exynos4-gpio";
|
|
reg = <0x11400000 0x20>;
|
|
#gpio-cells = <4>;
|
|
gpio-controller;
|
|
};
|