forked from Minki/linux
83619ea08e
Partitions are described in the same way for all mtd devices when using devicetree, move the documentation to a separate file and add references to it. Signed-off-by: Jamie Lentin <jm@lentin.co.uk> Acked-by: Arnd Bergmann <arnd@arndb.de> Acked-by: Jason Cooper <jason@lakedaemon.net> Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
48 lines
1.6 KiB
Plaintext
48 lines
1.6 KiB
Plaintext
GPIO assisted NAND flash
|
|
|
|
The GPIO assisted NAND flash uses a memory mapped interface to
|
|
read/write the NAND commands and data and GPIO pins for the control
|
|
signals.
|
|
|
|
Required properties:
|
|
- compatible : "gpio-control-nand"
|
|
- reg : should specify localbus chip select and size used for the chip. The
|
|
resource describes the data bus connected to the NAND flash and all accesses
|
|
are made in native endianness.
|
|
- #address-cells, #size-cells : Must be present if the device has sub-nodes
|
|
representing partitions.
|
|
- gpios : specifies the gpio pins to control the NAND device. nwp is an
|
|
optional gpio and may be set to 0 if not present.
|
|
|
|
Optional properties:
|
|
- bank-width : Width (in bytes) of the device. If not present, the width
|
|
defaults to 1 byte.
|
|
- chip-delay : chip dependent delay for transferring data from array to
|
|
read registers (tR). If not present then a default of 20us is used.
|
|
- gpio-control-nand,io-sync-reg : A 64-bit physical address for a read
|
|
location used to guard against bus reordering with regards to accesses to
|
|
the GPIO's and the NAND flash data bus. If present, then after changing
|
|
GPIO state and before and after command byte writes, this register will be
|
|
read to ensure that the GPIO accesses have completed.
|
|
|
|
The device tree may optionally contain sub-nodes describing partitions of the
|
|
address space. See partition.txt for more detail.
|
|
|
|
Examples:
|
|
|
|
gpio-nand@1,0 {
|
|
compatible = "gpio-control-nand";
|
|
reg = <1 0x0000 0x2>;
|
|
#address-cells = <1>;
|
|
#size-cells = <1>;
|
|
gpios = <&banka 1 0 /* rdy */
|
|
&banka 2 0 /* nce */
|
|
&banka 3 0 /* ale */
|
|
&banka 4 0 /* cle */
|
|
0 /* nwp */>;
|
|
|
|
partition@0 {
|
|
...
|
|
};
|
|
};
|