linux/drivers/media/platform
Philipp Zabel 074e8db02c media: coda: reduce minimum frame size to 48x16 pixels.
Three macroblocks seem to be the minimum resolution that can be encoded
and decoded by the CODA960 h.264 codec. Picture run commands fail for
smaller resolutions.

Signed-off-by: Philipp Zabel <p.zabel@pengutronix.de>
Signed-off-by: Hans Verkuil <hansverk@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab+samsung@kernel.org>
2018-11-23 05:27:25 -05:00
..
am437x media: vidioc_cropcap -> vidioc_g_pixelaspect 2018-11-20 13:57:21 -05:00
atmel media: v4l: fwnode: Initialise the V4L2 fwnode endpoints to zero 2018-10-04 16:21:02 -04:00
cadence media: v4l: fwnode: Initialise the V4L2 fwnode endpoints to zero 2018-10-04 16:21:02 -04:00
cec-gpio media: cec-gpio: support 5v testing 2018-07-25 07:12:36 -04:00
coda media: coda: reduce minimum frame size to 48x16 pixels. 2018-11-23 05:27:25 -05:00
cros-ec-cec media: platform: Add ChromeOS EC CEC driver 2018-07-13 08:44:46 +01:00
davinci media: vidioc_cropcap -> vidioc_g_pixelaspect 2018-11-20 13:57:21 -05:00
exynos4-is media: exynos4-is: convert g/s_crop to g/s_selection 2018-11-20 13:53:20 -05:00
exynos-gsc media: exynos-gsc: replace v4l2_crop by v4l2_selection 2018-11-20 13:46:06 -05:00
marvell-ccic media: v4l: mediabus: Recognise CSI-2 D-PHY and C-PHY 2018-10-04 16:06:15 -04:00
meson media: platform: meson-ao-cec: make busy TX warning silent 2018-07-24 17:52:20 -04:00
mtk-jpeg media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
mtk-mdp media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
mtk-vcodec media: mtk-vcodec: Release device nodes in mtk_vcodec_init_enc_pm() 2018-11-23 04:34:10 -05:00
mtk-vpu media: VPU: mediatek: don't pass an unused parameter 2018-10-04 14:27:16 -04:00
omap media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
omap3isp media: omap3isp: Unregister media device as first 2018-11-06 07:11:06 -05:00
qcom media: venus: change the default value of GOP size 2018-11-23 04:34:16 -05:00
rcar-vin media: vidioc_cropcap -> vidioc_g_pixelaspect 2018-11-20 13:57:21 -05:00
rockchip/rga media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
s3c-camif media updates for v4.20-rc1 2018-10-31 10:53:29 -07:00
s5p-cec media: s5p-cec: add NACK detection support 2017-09-23 07:29:30 -04:00
s5p-g2d media: s5p-g2d: convert g/s_crop to g/s_selection 2018-11-20 13:53:57 -05:00
s5p-jpeg media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
s5p-mfc media: s5p_mfc_dec.c: convert g_crop to g_selection 2018-11-20 13:47:46 -05:00
seco-cec media: seco-cec: add Consumer-IR support 2018-11-22 13:17:10 -05:00
soc_camera media updates for v4.20-rc1 2018-10-31 10:53:29 -07:00
sti media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
stm32 media: v4l: fwnode: Initialise the V4L2 fwnode endpoints to zero 2018-10-04 16:21:02 -04:00
sunxi/sun6i-csi media: sun6i: Add A31 compatible 2018-11-23 05:16:29 -05:00
tegra-cec media: tegra-cec: reset rx_buf_cnt when start bit detected 2018-03-05 07:46:24 -05:00
ti-vpe media: v4l: mediabus: Recognise CSI-2 D-PHY and C-PHY 2018-10-04 16:06:15 -04:00
vicodec media: vicodec: Add support for 4 planes formats 2018-11-23 04:34:32 -05:00
vimc media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
vivid media: vivid: use V4L2_FRACT_COMPARE 2018-11-23 04:34:00 -05:00
vsp1 media: vsp1: Document max_width restriction on UDS 2018-09-17 14:54:20 -04:00
xilinx media: platform: Switch to v4l2_async_notifier_add_subdev 2018-10-04 15:55:38 -04:00
fsl-viu.c media: replace strcpy() by strscpy() 2018-09-11 13:32:17 -04:00
imx-pxp.c media: imx-pxp: include linux/interrupt.h 2018-10-04 14:30:14 -04:00
imx-pxp.h media: imx-pxp: add i.MX Pixel Pipeline driver 2018-09-11 13:32:17 -04:00
Kconfig media: sun6i: Add support for Allwinner CSI V3s 2018-11-23 05:15:59 -05:00
m2m-deinterlace.c media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
Makefile media: sun6i: Add support for Allwinner CSI V3s 2018-11-23 05:15:59 -05:00
mx2_emmaprp.c media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
pxa_camera.c media: v4l: fwnode: Initialise the V4L2 fwnode endpoints to zero 2018-10-04 16:21:02 -04:00
rcar_drif.c media updates for v4.20-rc1 2018-10-31 10:53:29 -07:00
rcar_fdp1.c media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
rcar_jpu.c media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
rcar-fcp.c Char/Misc driver patches for 4.19-rc1 2018-08-18 11:04:51 -07:00
renesas-ceu.c media: renesas-ceu: Use default mbus settings 2018-10-04 16:25:33 -04:00
sh_veu.c media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
sh_vou.c media: use strscpy() instead of strlcpy() 2018-09-11 13:32:17 -04:00
via-camera.c media: replace strcpy() by strscpy() 2018-09-11 13:32:17 -04:00
via-camera.h media: fix usage of whitespaces and on indentation 2018-01-04 13:12:01 -05:00
video-mux.c media: platform: video-mux: Register a subdev notifier 2018-10-04 15:35:08 -04:00
vim2m.c media: vim2m/vicodec: set device_caps in video_device struct 2018-11-23 04:34:22 -05:00