forked from Minki/linux
ad8dc96e3b
Add a GPIO 1-wire bus master driver. The driver used the GPIO API to control the wire and the GPIO pin can be specified using platform data similar to i2c-gpio. The driver was tested with AT91SAM9260 + DS2401. Signed-off-by: Ville Syrjala <syrjala@sci.fi> Cc: Evgeniy Polyakov <johnpol@2ka.mipt.ru> Cc: David Brownell <david-b@pacbell.net> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
57 lines
1.5 KiB
Plaintext
57 lines
1.5 KiB
Plaintext
#
|
|
# 1-wire bus master configuration
|
|
#
|
|
|
|
menu "1-wire Bus Masters"
|
|
|
|
config W1_MASTER_MATROX
|
|
tristate "Matrox G400 transport layer for 1-wire"
|
|
depends on PCI
|
|
help
|
|
Say Y here if you want to communicate with your 1-wire devices
|
|
using Matrox's G400 GPIO pins.
|
|
|
|
This support is also available as a module. If so, the module
|
|
will be called matrox_w1.ko.
|
|
|
|
config W1_MASTER_DS2490
|
|
tristate "DS2490 USB <-> W1 transport layer for 1-wire"
|
|
depends on USB
|
|
help
|
|
Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges,
|
|
for example DS9490*.
|
|
|
|
This support is also available as a module. If so, the module
|
|
will be called ds2490.ko.
|
|
|
|
config W1_MASTER_DS2482
|
|
tristate "Maxim DS2482 I2C to 1-Wire bridge"
|
|
depends on I2C && EXPERIMENTAL
|
|
help
|
|
If you say yes here you get support for the Maxim DS2482
|
|
I2C to 1-Wire bridge.
|
|
|
|
This driver can also be built as a module. If so, the module
|
|
will be called ds2482.
|
|
|
|
config W1_MASTER_DS1WM
|
|
tristate "Maxim DS1WM 1-wire busmaster"
|
|
depends on W1 && ARM
|
|
help
|
|
Say Y here to enable the DS1WM 1-wire driver, such as that
|
|
in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like
|
|
hx4700.
|
|
|
|
config W1_MASTER_GPIO
|
|
tristate "GPIO 1-wire busmaster"
|
|
depends on GENERIC_GPIO
|
|
help
|
|
Say Y here if you want to communicate with your 1-wire devices using
|
|
GPIO pins. This driver uses the GPIO API to control the wire.
|
|
|
|
This support is also available as a module. If so, the module
|
|
will be called w1-gpio.ko.
|
|
|
|
endmenu
|
|
|