forked from Minki/linux
014fd22ef9
Signed-off-by: Xiubo Li <Li.Xiubo@freescale.com> Signed-off-by: Mark Brown <broonie@linaro.org>
43 lines
1.7 KiB
Plaintext
43 lines
1.7 KiB
Plaintext
Freescale Synchronous Audio Interface (SAI).
|
|
|
|
The SAI is based on I2S module that used communicating with audio codecs,
|
|
which provides a synchronous audio interface that supports fullduplex
|
|
serial interfaces with frame synchronization such as I2S, AC97, TDM, and
|
|
codec/DSP interfaces.
|
|
|
|
|
|
Required properties:
|
|
- compatible: Compatible list, contains "fsl,vf610-sai" or "fsl,imx6sx-sai".
|
|
- reg: Offset and length of the register set for the device.
|
|
- clocks: Must contain an entry for each entry in clock-names.
|
|
- clock-names : Must include the "bus" for register access and "mclk1" "mclk2"
|
|
"mclk3" for bit clock and frame clock providing.
|
|
- dmas : Generic dma devicetree binding as described in
|
|
Documentation/devicetree/bindings/dma/dma.txt.
|
|
- dma-names : Two dmas have to be defined, "tx" and "rx".
|
|
- pinctrl-names: Must contain a "default" entry.
|
|
- pinctrl-NNN: One property must exist for each entry in pinctrl-names.
|
|
See ../pinctrl/pinctrl-bindings.txt for details of the property values.
|
|
- big-endian: Boolean property, required if all the FTM_PWM registers
|
|
are big-endian rather than little-endian.
|
|
- big-endian-data: If this property is absent, the little endian mode will
|
|
be in use as default, or the big endian mode will be in use for all the
|
|
fifo data.
|
|
|
|
Example:
|
|
sai2: sai@40031000 {
|
|
compatible = "fsl,vf610-sai";
|
|
reg = <0x40031000 0x1000>;
|
|
pinctrl-names = "default";
|
|
pinctrl-0 = <&pinctrl_sai2_1>;
|
|
clocks = <&clks VF610_CLK_PLATFORM_BUS>,
|
|
<&clks VF610_CLK_SAI2>,
|
|
<&clks 0>, <&clks 0>;
|
|
clock-names = "bus", "mclk1", "mclk2", "mclk3";
|
|
dma-names = "tx", "rx";
|
|
dmas = <&edma0 0 VF610_EDMA_MUXID0_SAI2_TX>,
|
|
<&edma0 0 VF610_EDMA_MUXID0_SAI2_RX>;
|
|
big-endian;
|
|
big-endian-data;
|
|
};
|