This patch fixes an oops cause by pm_trigger accessing the (uninitialised)
crtc list.
Reported-by: Roy Spliet <r.spliet@student.tudelft.nl>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
NV20/NV30 is partially educated guesswork at this point, based on any
information around about available memory types and a horribly unspeakable
amount of vbios image scouring. I'm not entirely certain the GDDR3 define
is correct, I have not spotted a single vbios with that value yet (though
it is mentioned in some 1218-using nv4x vbios), but there are reports that
some nv3x did use it..
NV40(100914) confirmed by switching an NV49 to DDR1/DDR2 values and making
sure that the binary driver behaviour showed it had detected DDR1/DDR2
instead of GDDR3 before dying horribly.
NV40(100474) confirmed by doing much the same task as above on an NV44,
except this was *much* easier as changing the values didn't seem to have
any noticable effect on the memory controller aside from changing the
binary driver's behaviour.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The current enabling of bus mastering in the drm midlayer allows a large
race condition under kexec. When a kexec'ed kernel re-enables bus mastering
for the GPU, previously setup dma blocks may cause writes to random pieces
of memory. On radeon the writeback mechanism can cause these sorts of issues.
This patch doesn't fix the problem, but it moves the bus master enable under
the individual drivers control so they can move enabling it until later in
their load cycle and close the race.
Fix for radeon kms driver will be in a follow-up patch.
Signed-off-by: Dave Airlie <airlied@redhat.com>
Newer nVidia cards with Optimus do not support/use the DSM switching functions.
Instead, it require a DSM function to be called prior to bringing a device into
D3 state. No other _DSM calls are necessary before/after enabling/disabling a
device. Switching between discrete and integrated GPU is not supported by
this Optimus _DSM call, therefore return on the switching method.
Signed-off-by: Peter Lekensteyn <lekensteyn@gmail.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>
- moves out of nouveau_bios.c and demagics the logical state definitions
- simplifies chipset-specific driver interface
- makes most of gpio irq handling common, will use for nv4x hpd later
- api extended to allow both direct gpio access, and access using the
logical function states
- api extended to allow for future use of gpio extender chips
- pre-nv50 was handled very badly, the main issue being that all GPIOs
were being treated as output-only.
- fixes nvd0 so gpio changes actually stick, magic reg needs bashing
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
This area is horrifically complicated on these chipsets, and it's likely we
will need at least a few more tweaks yet.
Oh yes, and it's completely disabled on IGPs for the moment. From traces,
things look potentially different there yet again. Sigh...
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
A NV49 appeared a while back that was using the "nv41 style" pwm registers,
rather than the "nv40 style" ones my board is using. This disproves the
previous theory that the pwm controller choice is chipset-specific.
So, after looking at a bunch of vbios images it appears that the next viable
theory is that we should select the pwm controller to use based on the gpio
line the fan is tied to, just like we do on nv50.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Not 100% perfect yet, but a good start towards what it'll look like in the
end.
Actually seems stable on a NV44 I have here, as much as running around OA
for a fair amount of time constantly switching between performance levels
can prove..
My NV49 isn't quite so happy, and semaphores mess up somehow (sometimes) as
a result of the memory reclocking.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
I'm sure that out there somewhere, someone will need this. We currently
haven't seen an example of LVDS being on a non-0 SOR so far though.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
NV30: Create framework for memtm
NV50: Improve reg creation,
NV50: Use P.version instead of card codename/stepping,
NVC0: Initial memtiming code for Fermi,
Renamed regs for consistency,
Overall redesign to improve readability,
Avoid kfree on null-pointer
Signed-off-by: Roy Spliet <r.spliet@student.tudelft.nl>
All the non-stubbed functions should be okay for this chipset, the rest
will be added back as they're figured out.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
