Otherwise, we can have a stale state after a disconnect and reconnect
causing errors on the first SETUP packet to the device.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
This bit should be only set when the port enable goes down, for
example, on errors. Not when it gets set after a port reset. Some
USB stacks seem to be sensitive to this and fails enumeration.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
Commit 08f871a3ac ("usb: dwc3: host: convey the PHYs to xhci") added
forwarding of the generic PHYs from DWC3 core to the instantiated XHCI-plat
device. However XHCI(-plat) driver never gained support for generic PHYs,
thus the lookup added by that commit is never used. In meantime the commit
d64ff406e5 ("usb: dwc3: use bus->sysdev for DMA configuration")
incorrectly changed the device used for creating lookup, making the lookup
useless and generic PHYs inaccessible from XHCI device.
However since commit 178a0bce05 ("usb: core: hcd: integrate the PHY
wrapper into the HCD core") USB HCD already handles generic PHYs acquired
from the HCD's 'sysdev', which in this case is DWC3 core device. This means
that creating any custom lookup entries for XHCI driver is no longer needed
and can be simply removed.
Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
It has been requested that usbfs should implement runtime power
management, instead of forcing the device to remain at full power as
long as the device file is open. This patch introduces that new
feature.
It does so by adding three new usbfs ioctls:
USBDEVFS_FORBID_SUSPEND: Prevents the device from going into
runtime suspend (and causes a resume if the device is already
suspended).
USBDEVFS_ALLOW_SUSPEND: Allows the device to go into runtime
suspend. Some time may elapse before the device actually is
suspended, depending on things like the autosuspend delay.
USBDEVFS_WAIT_FOR_RESUME: Blocks until the call is interrupted
by a signal or at least one runtime resume has occurred since
the most recent ALLOW_SUSPEND ioctl call (which may mean
immediately, even if the device is currently suspended). In
the latter case, the device is prevented from suspending again
just as if FORBID_SUSPEND was called before the ioctl returns.
For backward compatibility, when the device file is first opened
runtime suspends are forbidden. The userspace program can then allow
suspends whenever it wants, and either resume the device directly (by
forbidding suspends again) or wait for a resume from some other source
(such as a remote wakeup). URBs submitted to a suspended device will
fail or will complete with an appropriate error code.
This combination of ioctls is sufficient for user programs to have
nearly the same degree of control over a device's runtime power
behavior as kernel drivers do.
Still lacking is documentation for the new ioctls. I intend to add it
later, after the existing documentation for the usbfs userspace API is
straightened out into a reasonable form.
Suggested-by: Mayuresh Kulkarni <mkulkarni@opensource.cirrus.com>
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Link: https://lore.kernel.org/r/Pine.LNX.4.44L0.1908071013220.1514-100000@iolanthe.rowland.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
USB drivers now support the ability for the driver core to handle the
creation and removal of device-specific sysfs files in a race-free
manner. Take advantage of that by converting the driver to use this by
moving the sysfs attributes into a group and assigning the dev_groups
pointer to it.
Link: https://lore.kernel.org/r/20190806144502.17792-12-gregkh@linuxfoundation.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
USB drivers now support the ability for the driver core to handle the
creation and removal of device-specific sysfs files in a race-free
manner. Take advantage of that by converting the driver to use this by
moving the sysfs attributes into a group and assigning the dev_groups
pointer to it.
Link: https://lore.kernel.org/r/20190806144502.17792-4-gregkh@linuxfoundation.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
USB drivers now support the ability for the driver core to handle the
creation and removal of device-specific sysfs files in a race-free
manner. Take advantage of that by converting the driver to use this by
moving the sysfs attributes into a group and assigning the dev_groups
pointer to it.
Link: https://lore.kernel.org/r/20190806144502.17792-9-gregkh@linuxfoundation.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
USB drivers now support the ability for the driver core to handle the
creation and removal of device-specific sysfs files in a race-free
manner. Take advantage of that by converting the driver to use this by
moving the sysfs attributes into a group and assigning the dev_groups
pointer to it.
Link: https://lore.kernel.org/r/20190806144502.17792-8-gregkh@linuxfoundation.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
USB drivers now support the ability for the driver core to handle the
creation and removal of device-specific sysfs files in a race-free
manner. Take advantage of that by converting the driver to use this by
moving the sysfs attributes into a group and assigning the dev_groups
pointer to it.
Link: https://lore.kernel.org/r/20190806144502.17792-10-gregkh@linuxfoundation.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Mark switch cases where we are expecting to fall through.
This patch fixes the following warning (Building: tct_hammer_defconfig arm):
drivers/usb/gadget/udc/s3c2410_udc.c:314:7: warning: this statement may fall through [-Wimplicit-fallthrough=]
drivers/usb/gadget/udc/s3c2410_udc.c:418:7: warning: this statement may fall through [-Wimplicit-fallthrough=]
Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>
Link: https://lore.kernel.org/r/20190805191426.GA12414@embeddedor
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Mark switch cases where we are expecting to fall through.
This patch fixes the following warning (Building: at91_dt_defconfig arm):
drivers/usb/gadget/udc/atmel_usba_udc.c:329:13: warning: this statement may fall through [-Wimplicit-fallthrough=]
Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>
Link: https://lore.kernel.org/r/20190805184842.GA8627@embeddedor
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Starting from DWC_usb31 version 1.90a and later, the DCTL.CSFRST bit
will not be cleared until after all the internal clocks are synchronized
during soft-reset. This may take a little more than 50ms. Set the
polling rate at 20ms instead.
Signed-off-by: Thinh Nguyen <thinhn@synopsys.com>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
Instead of using to_pci_dev + pci_get_drvdata,
use dev_get_drvdata to make code simpler.
Signed-off-by: Chuhong Yuan <hslester96@gmail.com>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
When a gadget is disabled, kill_all_requests() can be called
simultaneously from both a user process via dwc2_hsotg_pullup() and from
the interrupt handler if the hardware detects disconnection.
Since we drop the lock in dwc2_hsotg_complete_request() in order to call
the completion handler, this means that the list is modified
concurrently and leads to an infinite loop in kill_all_requests().
Replace the foreach loop with a while-not-empty loop in order to remove
the danger of this concurrent modification.
Note: I observed this with threadirqs, I'm not sure if it can be
triggered without threaded interrupts.
Signed-off-by: John Keeping <john@metanate.com>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
Mark switch cases where we are expecting to fall through.
This patch fixes the following warning (Building: at91_dt_defconfig arm):
drivers/usb/gadget/udc/atmel_usba_udc.c:329:13: warning: this statement may fall through [-Wimplicit-fallthrough=]
Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
Mark switch cases where we are expecting to fall through.
This patch fixes the following warning (Building: tct_hammer_defconfig arm):
drivers/usb/gadget/udc/s3c2410_udc.c:314:7: warning: this statement may fall through [-Wimplicit-fallthrough=]
drivers/usb/gadget/udc/s3c2410_udc.c:418:7: warning: this statement may fall through [-Wimplicit-fallthrough=]
Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
Currently, the authorized_default and interface_authorized_default
attributes for HCD are set up after the uevent has been sent to userland.
This creates a race condition where userland may fail to access this
file when processing the event. Move the appending of these attributes
earlier relying on the usb_bus_notify dispatcher.
Signed-off-by: Thiébaud Weksteen <tweek@google.com>
Cc: stable <stable@vger.kernel.org>
Link: https://lore.kernel.org/r/20190806110050.38918-1-tweek@google.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Now that the driver core supports dev_groups for individual drivers,
expose that pointer to struct usb_device_driver to make it easier for USB
drivers to also use it.
Yes, users of usb_device_driver are much rare, but there are instances
already that use custom sysfs files, so adding this support will make
things easier for those drivers. usbip is one example, hubs might be
another one.
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Link: https://lore.kernel.org/r/20190806144502.17792-3-gregkh@linuxfoundation.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
