A couple of accesses to IRQEN (base+0x00) just used "base" directly, so
they would break if IRQEN ever became nonzero. Make sure that all
reads/writes specify the register offset constant.
Signed-off-by: Kevin Cernekee <cernekee@gmail.com>
Acked-by: Florian Fainelli <f.fainelli@gmail.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Link: https://lkml.kernel.org/r/1415342669-30640-9-git-send-email-cernekee@gmail.com
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
This check may be prone to race conditions, e.g.
1) Some external event (e.g. GPIO level) causes an IRQ to become pending
2) Peripheral asserts the L2 IRQ
3) CPU takes an interrupt
4) The event from #1 goes away
5) bcm7120_l2_intc_irq_handle() reads back a 0 status
Unlike the hardware supported by brcmstb-l2, the bcm7120-l2 controller
does not latch the IRQ status. Bits can change if the inputs to the
controller change. Also, do_bad_IRQ() is an ARM-specific macro.
So let's just nuke it.
Signed-off-by: Kevin Cernekee <cernekee@gmail.com>
Acked-by: Florian Fainelli <f.fainelli@gmail.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Link: https://lkml.kernel.org/r/1415342669-30640-7-git-send-email-cernekee@gmail.com
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
This patch adds support for the Level-2 interrupt controller
hardware found in Broadcom Set Top Box System-on-a-Chip devices. This
interrupt controller is implemented using a single enable register.
This interrupt controller is always present on the platforms supported
by the irq-brcmstb-l2 driver, hence the reason why both are compiled
using the same Kconfig symbol.
[jac] removed the following warning:
drivers/irqchip/irq-bcm7120-l2.c: In function 'bcm7120_l2_intc_irq_handle':
drivers/irqchip/irq-bcm7120-l2.c:49:27: warning: unused variable 'gc' [-Wunused-variable]
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Link: https://lkml.kernel.org/r/1410309862-27784-2-git-send-email-f.fainelli@gmail.com
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
