Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

No conflicts.

Signed-off-by: Jakub Kicinski <kuba@kernel.org>

Documentation/devicetree/bindings/net/ethernet-controller.yaml

@@ -106,6 +106,12 @@ properties:
   phy-mode:
     $ref: "#/properties/phy-connection-type"
 
+  pcs-handle:
+    $ref: /schemas/types.yaml#/definitions/phandle
+    description:
+      Specifies a reference to a node representing a PCS PHY device on a MDIO
+      bus to link with an external PHY (phy-handle) if exists.
+
   phy-handle:
     $ref: /schemas/types.yaml#/definitions/phandle
     description:

Documentation/devicetree/bindings/net/micrel.txt

@@ -45,20 +45,3 @@ Optional properties:
 
 	In fiber mode, auto-negotiation is disabled and the PHY can only work in
 	100base-fx (full and half duplex) modes.
-
- - lan8814,ignore-ts: If present the PHY will not support timestamping.
-
-	This option acts as check whether Timestamping is supported by
-	hardware or not. LAN8814 phy support hardware tmestamping.
-
- - lan8814,latency_rx_10: Configures Latency value of phy in ingress at 10 Mbps.
-
- - lan8814,latency_tx_10: Configures Latency value of phy in egress at 10 Mbps.
-
- - lan8814,latency_rx_100: Configures Latency value of phy in ingress at 100 Mbps.
-
- - lan8814,latency_tx_100: Configures Latency value of phy in egress at 100 Mbps.
-
- - lan8814,latency_rx_1000: Configures Latency value of phy in ingress at 1000 Mbps.
-
- - lan8814,latency_tx_1000: Configures Latency value of phy in egress at 1000 Mbps.

Documentation/devicetree/bindings/net/xilinx_axienet.txt

@@ -26,7 +26,8 @@ Required properties:
 		  specified, the TX/RX DMA interrupts should be on that node
 		  instead, and only the Ethernet core interrupt is optionally
 		  specified here.
-- phy-handle	: Should point to the external phy device.
+- phy-handle	: Should point to the external phy device if exists. Pointing
+		  this to the PCS/PMA PHY is deprecated and should be avoided.
 		  See ethernet.txt file in the same directory.
 - xlnx,rxmem	: Set to allocated memory buffer for Rx/Tx in the hardware
 
@@ -68,6 +69,11 @@ Optional properties:
 		  required through the core's MDIO interface (i.e. always,
 		  unless the PHY is accessed through a different bus).
 
+ - pcs-handle: 	  Phandle to the internal PCS/PMA PHY in SGMII or 1000Base-X
+		  modes, where "pcs-handle" should be used to point
+		  to the PCS/PMA PHY, and "phy-handle" should point to an
+		  external PHY if exists.
+
 Example:
 	axi_ethernet_eth: ethernet@40c00000 {
 		compatible = "xlnx,axi-ethernet-1.00.a";